Download Print this page

Frigidaire FPRU19F8RF Product Dimensions page 3

18.6 cu. ft.
Hide thumbs Also See for FPRU19F8RF:

Advertisement

24"
Cabinet
(Single Trim Kit shown.)
A
C
B
Reversible Kickplate
All-
Built-In Installation
(without Trim Kit)
Refrigerator
Single Unit
Cutout
(A) 72" (B) 33" (C) 25
Dimensions
Double Unit (Side-by-Side)
(A) 72" (B) 66" (C) 25
Built-In All-Refrigerator Specifications
Product Shipping Weight – 245 Lbs.
An electrical supply with grounded three-prong receptacle is required.
The power supply circuit must be installed in accordance with current
edition of National Electrical Code (NFPA 70) and local codes &
ordinances.
Voltage Rating – 115V / 60 Hz / 20 Amps
Connected Load (kW Rating) @ 115 Volts = 0.55 kW
Amps @ 115 Volts = 15 Amps
Always consult local and national electric codes.
Minimum 25-1/4" depth requires recessed electrical outlet.
To allow for ease of installation, tape excess power cord to back of unit.
When installing refrigerator adjacent to wall, cabinet or other appliance
that extends beyond front edge of unit, 20" minimum clearance
recommended to allow for optimum 140° door swing, providing
complete drawer / crisper access and removal. (Absolute 4" minimum
clearance will ONLY allow for 90° door swing which will provide limited
drawer / crisper access with restricted removal.)
Minimum 3/8" clearance required for sides and top of refrigerator or
freezer with 1" clearance at rear to allow for ease of installation, proper
air circulation, and plumbing / electrical connections.
To ensure optimum performance, (do not install in areas where
temperature drops below 55° F or rises above 110° F) and
avoid installing in direct sunlight or close proximity to range,
dishwasher or other heat source.
USA
10200 David Taylor Drive
Charlotte, NC 28262
CANADA
5855 Terry Fox Way
Mississauga, ON L5V 3E4
FPRU19F8R 07/15
Recessed electrical outlet
25
/
" min. side panels,
1
4
1
/
" min. width
2
Countertop
(Trim Kit installation requires
/
" min. width)
3
4
Top Trim Piece
Optional Trim Kits
(for 75" opening)
& Dimensions
Kits include top and side trim
pieces, louvered grille, reversible
Louvered Grille
kickplate and leveling system to
(for 79" opening)
fit 75" or 79" opening height.
Single Louvered Trim Kit
PN # TRIMKITEZ1
(D) 75
1
/
" or 79
8
Trim Kit
Double Louvered Trim Kit
PN # TRIMKITEZ2
D
(Includes hardware to secure
side-by-side units together.)
Cut off
(D) 75
/
" or 79
1
4" for 75"
8
opening
Note: Both kits attach
directly to cabinetry through
top trim piece or louvered
4"
grille to stabilize unit(s).
Refer to detailed kit installation
E
instructions packed with
kit or on web.
Built-In Installation
(with Trim Kit & Leveling System)
Single Unit
/
" min.
(A) 75" or 79" (B) 33" (C) 25
1
4
Double Unit (Side-by-Side)
1
/
" min.
(A) 75" or 79" (B) 66" (C) 25
4
1-800-FRIGIDAIRE
frigidaire.com
1-800-265-8352
frigidaire.ca
© 2015 Electrolux Home Products, Inc.
26
/
"
1
2
25"
71
/
"*
3
8
1
/
" (E) 34
3
/
"
8
4
/
" (E) 67
/
"
1
1
8
8
Allow at least
57
/
" for overall depth
3
8
with door in 90°
open position
Leveling System
(2) per unit raises height 2-9/16" min.
Only available with trim kits.
/
" min.
1
4
Minimum depth from face of cabinet side
1
/
" min.
panels and requires recessed electrical outlet.
4
Refrigerator must be placed on level surface of hard material, same
height as flooring. Surface must support approximately 800 lbs. when
fully loaded. Unit equipped with 4-point leveling.
"Built-In Look" Specifications
Minimum opening of 72" H x 33" W x 25-1/4" D required for single-
unit "Built-In Look" installation; 66" W required for double-unit
installation. (72" H to be measured from finished floor to underside
of soffit or overhead cabinet.)
Remove all wall / floor molding prior to built-in installation.
Optional Trim Kit Specifications
If optional Single or Double Louvered Trim Kit is to be used, different
cutout dimensions are required. Kit can be adapted to fit either 75"
or 79" opening height. (Refer to cutout dimensions on this page and
detailed Louvered Trim Kit installation instructions included with kit
or on web.)
Remove all wall / floor molding prior to built-in installation.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
Single Louvered Trim Kit – (PN # TRIMKITEZ1).
Double Louvered Trim Kit – (PN # TRIMKITEZ2).
PureAdvantage® Air Filter
Replacement Cartridge – (PN # 241754001).
All Refrigerator
FPRU19F8RF
18.6 Cu. Ft.
32"
7
/
"
16
70
/
"*
3
16
Power
cord
location
(right
bottom
rear)
23
1
/
"
2
28
/
" to handle
1
4
extension
*Height without
leveling system
Specifications
subject to change.

Advertisement

loading