Warmer Drawer Stand-Alone Installation
Warmer Drawer Specifications
•
Product Shipping Weight (approx.) – 60 Lbs.
•
Voltage Rating – 120V / 450W / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 0.5 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
•
Amps @ 120V = 3.8 Amps
•
Recommended Circuit Breaker – 15 Amps
30" Warmer Drawer/ 30" Single
Wall Oven Combination Installation
30" Warmer Drawer / Wall Oven Combination Specifications
•
To support Wall Oven when using in combination with Warmer
Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base,
capable of supporting 200 Lbs. Do NOT use full base, since planks
are necessary to allow for proper air displacement.
USA
10200 David Taylor Drive
Charlotte, NC 28262
•
•
CANADA
5855 Terry Fox Way
Mississauga, ON L5V 3E4
•
•
FGWD3065P 12/13
1-800-FRIGIDAIRE
frigidaire.com
•
•
1-800-265-8352
frigidaire.ca
•
•
© 2013 Electrolux Home Products, Inc.
•
Always consult local and national electric codes.
•
Full plywood base required, capable of supporting 100 Lbs.
•
Base must be level and cabinet front must be square.
•
Warmer Drawer can be used alone, or is approved to be used in
combination with any Frigidaire® Wall Oven. (Refer to Combination
Installation Specifications and drawing on this page.)
Warmer Drawer is approved to be used in combination with any
•
Frigidaire® Built-In Microwave and /or Electric Single Wall Oven.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Accessories information available
on the web at frigidaire.com
Warmer Drawer
FGWD3065PF
30" Electric
Specifications
subject to change.