Download Print this page

Frigidaire 318201822 Installation Instructions Manual

Frigidaire warmer drawer installation instructions.
Hide thumbs

Advertisement

WARMER DRAWER INSTALLATION INSTRUCTIONS
Canada
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
flammable vapors and liquids in the vicinity of this or any other appliance.
GENERAL INFORMATION - The Warmer Drawer can
be used as a stand alone appliance or as a combination
Warmer Drawer with a built-in oven mounted above.
NOTE: A 60" (152,4 cm) long cable is supplied with
the Warmer Drawer.
Stand Alone Installation
C
B
F
D
E
Minimum distance to
floor 4½" (11,4 cm)
FLOOR
A. HEIGHT
27" Models
11 ¼" (28,6 cm)
30" Models
11 ¼" (28,6 cm)
D. CUTOUT
HEIGHT
27" Models - Min.
9
/
" (25,1 cm)
7
8
Max.
10 ¼" (26 cm)
30" Models - Min.
9
/
" (25,1 cm)
7
8
Max.
10 ¼" (26 cm)
* Note: It is also possible to install this warmer drawer in a height opening
of 9¼" (23,5 cm). Please refer to page 3 for complete instructions.
Printed in United States
INSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED INSTALLER.
WARNING
FOR YOUR SAFETY: Do not store or use gasoline or other
Warmer Drawer Dimensions
60" (152,4 cm)
Cord
Warmer Drawer
A
Warmer Drawer
Cutout
B. WIDTH
C. DEPTH
27" (68,6 cm)
23
/
" (59,4 cm)
3
8
30" (76,2 cm)
23
/
" (59,4 cm)
3
8
E. CUTOUT
F. CUTOUT
WIDTH
DEPTH
25 ½" (64,8 cm)
23
/
" (60 cm)
5
8
25 ¾" (65,4 cm)
24" (61 cm)
28 ½" (72,4 cm)
23
/
" (60 cm)
5
8
28 ¾" (73 cm)
24" (61 cm)
IMPORTANT: The warmer drawer must be installed on a
surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45,4 Kg).
IMPORTANT: The Warmer Drawer runs off a single
phase three-wire 120 volt, 60 hertz, AC only electrical
supply with ground.
Combination Warmer Drawer / 27" (68,6 cm) or
30" (76,2 cm) Built-in Oven Installation
Caution: Two 3" (7,6 cm) wide X
¾" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds (90,7 Kg).
29
/
"
1
16
(73,8 cm)
H* =11
/
" (30,2 cm) Min. is the space between the
7
8
bottom of the drawer cutout and the bottom of the
oven cutout. This is a critical dimension and must be provided.
J** = 3" (7,6 cm) Max. Electrical Junction Box for wall oven can be
lower than warmer drawer cutout.
A. HEIGHT
27" Models 11 ¼" (28,6 cm)
30" Models 11 ¼" (28,6 cm)
D. CUTOUT
HEIGHT
27" - Min.
9
/
" (25,1 cm)
25 ½" (64,8 cm)
7
8
Max.
10 ¼" (26 cm)
25 ¾" (65.4 cm)
30" - Min.
9
/
" (25,1 cm)
28 ½" (72,4 cm)
7
8
Max.
10 ¼" (26 cm)
1
United States
B. WIDTH
C. DEPTH
27" (68,6 cm)
23
/
" (59,4 cm)
3
8
30" (76,2 cm)
23
/
" (59,4 cm)
3
8
E. CUTOUT
F. CUTOUT
G. HEIGHT
WIDTH
DEPTH
23
/
" (60 cm)
5
8
24" (61 cm)
Depends on critical
23
/
" (60 cm)
5
8
28 ¾" (73 cm)
24" (61 cm)
Depends on critical
P/N 318201822 (0901) Rev. A
English – pages 1-4
Español – páginas 5-8
Français – pages 9-12
2" (5,1 cm)
dimension H
2" (5,1 cm)
dimension H

Advertisement

   Summary of Contents for Frigidaire 318201822

  • Page 1

    24" (61 cm) " (25,1 cm) 28 ½" (72,4 cm) " (60 cm) 28 ¾" (73 cm) 24" (61 cm) P/N 318201822 (0901) Rev. A English – pages 1-4 Español – páginas 5-8 Français – pages 9-12 G. HEIGHT 2" (5,1 cm)

  • Page 2: Important Safety Instructions

    WARMER DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all the instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from the appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances. 4.

  • Page 3

    WARMER DRAWER INSTALLATION INSTRUCTIONS Model and Serial Number Location The serial plate is located as shown below. When ordering parts for or making inquiries about your Warm & Serve Drawer, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your Warm &...

  • Page 4

    WARMER DRAWER INSTALLATION INSTRUCTIONS Notes...

  • Page 5

    28 ½" (72,4 cm) 23 " (60 cm) 28 ¾" (73 cm) 24" (61 cm) dimensión crítica H P/N 318201822 (0901) Rev. A English – pages 1-4 Español – páginas 5-8 Français – pages 9-12 G. ALTO 2" (5,1 cm) Depende de la 2"...

  • Page 6

    INSTRUCCIONES DE INSTALACIóN PARA EL CAjóN CALENTADOR Notas importantes para el instalador 1. Lea todas las instrucciones de instalación antes de instalar el electrodoméstico. 2. Retire todos los materiales de empaque del electrodoméstico antes de conectar la fuente de energía. 3.

  • Page 7

    INSTRUCCIONES DE INSTALACIóN PARA EL CAjóN CALENTADOR Ubicación de la placa de serie Encontrará el número de serie y modelo impresos en la placa de serie. Cuando pida componentes o desee obtener informaciones sobre su cajón calentador, asegúrese de incluir el modelo y el número de serie o una letra o número de la placa con el número de serie de su cajón calentador.

  • Page 8

    INSTRUCCIONES DE INSTALACIóN PARA EL CAjóN CALENTADOR Notas...

  • Page 9

    24" (61 cm) " (25,1 cm) 28½" (72,4 cm) " (60 cm) 28¾" (73 cm) 24" (61 cm) P/N 318201822 (0901) Rev. A English – pages 1-4 Español – páginas 5-8 Français – pages 9-12 g. Hauteur 2" (5,1 cm) Dépend de la...

  • Page 10

    INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD Notes importantes à l’installateur 1. Lisez toutes les instructions d’installation avant de procéder à l’installation de cet appareil. 2. Retirez tout le matériel d’emballage de l’appareil avant de brancher l’alimentation électrique. 3. Observez tous les règlements et codes locaux applicables. 4.

  • Page 11

    INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD Emplacement des numéros de modèle et de série La plaque signalétique est située tel que montré plus bas. Lors d’une commande de pièces ou pour toute demande de renseignements au sujet de votre tiroir réchaud, assurez-vous de toujours inclure les numéros de modèle et de série inscrits sur la plaque signalétique de votre appareil.

  • Page 12

    INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD Notes...

Comments to this Manuals

Symbols: 0
Latest comments: