Table of Contents
Advertisement
EN
Front and back panel
Connections
The following diagram gives details of the connections on
the back of the loudspeaker:
SpeakerLink
output
Use this connection
SpeakerLink input
SpeakerLink output
Power
The loudspeakers are switched on or into standby as appropriate
via the SpeakerLink connections by the Meridian system they
are connected to.
Power
input
To connect to this
The SpeakerLink output of a Meridian
Audio Core or Digital Surround
Controller.
The SpeakerLink input of a second
DSP320 digital loudspeaker, when
connecting in a daisy-chain.
A captive power cord to connect to the
RF300 rough-in box power outlet.
Front panel
The following diagram gives details of the front of the
loudspeaker:
Right
I
Channel
O
II
selector
Mono
Left
Status indicator
and IR receiver
Switch
Description
Channel selector
Set to Left or Right to specify the
position of each loudspeaker, or Mono
for a mono mix.
Standby indicator
Status
Description
Blue
Loudspeaker in standby.
White
Loudspeaker operating.
At power-up flashes once if IR is off and
twice if IR is on.
To configure the IR receiver
Hold down one of the following keys on an MSR remote (not
supplied) while powering up the speaker:
Next: Turns on IR; white LED flashes twice.
Previous: Turns off IR; white LED flashes once.
Stop: Resets all to factory settings; white LED flashes 3 times.
DSP320 User Guide
Fuse
Fuse
On
~50-60Hz T5.0AH
250V for 100-230V~
CAUTION:
Disconnect supply before changing fuse.
Replace with same type fuse.
Off
ATTENTION:
Débrancher avant de remplacer le fusible.
Utiliser un fusible de rechange
du même type.
Power
switch
Advertisement
Table of Contents
