Maxplus Industries HTS 2100S+ User Manual page 8

6.1 Getting Started
2) Antenna Setup
Press the MENU button to display the main menu.
Use / and / to move in the menu.
CH VOL VOL
CH
Press on 'Dish Setting'. The following window will appear. <Figure 6-2>
If you have a motorized dish, press
Note : Enter a 4-Digit password if need arise. The default password is '0000'.
<Figure 6-2>
Select the item that you want to edit, and set its parameters as desired. <Dish Setting>
- LNB Power : Select among ON/OFF/13V/18V.
- LNB Type : Select among Single/Universal/OCS.
- LNB Freq : Set the frequency of the LNB oscillator.
- 22KHz : When not AUTO, set the signal path from LNB or switch by selecting a control signal
among 0/22KHz.
- DiSEqC switch : Select DiSEqC protocol among OFF/1.0/1.1 as appropriate for your
configuration.
- Committed/Uncommitted : Select the DiSEqC port.
Select the item that you want to edit and set its parameters as desired. <Motorized Setting>
- Frequency : If the default TP frequency is not appropriate, you can select another TP
frequency at which to check for signal.
- DiSEqC Motor : Select DiSEqC protocol among OFF/1.2/USALS as appropriate for your
Motor.
on 'Motorized Setting'. < Figure 6-3>
<Figure 6-3>
12
6.1 Getting Started
( When the DiSEqC Motor parameter is set as 1.2 )
- Move : You can move the dish to the West/East.
- Limit : If you want to set limits, press
- Disable Limit : You can disable the East and West limits.
- Goto Center : Move the dish to the initial 0 position.
- Set East / West Limit : Move the dish East or West using
Press to set East or West limit.
( When the DiSEqC Motor parameter is set as USALS )
- Sat Degree : Satellite location.
- Antenna Position : Press .
- Goto Reference : Move the dish to the reference 0 position.
- Antenna Longitude : Your longitude at present.
- Antenna Latitude : Your latitude at present.
Note : You need to know what LNB you are using to correctly set the L.O. (local
oscillator) frequency.
Note : You need to understand how your receiver is connected to properly set the
22KHz and DiSEqC.
When you are done, press the EXIT button.
.
/ .
VOL VOL
13