TP-Link RE590T User Manual page 25

Chapter 3
You can also manually reserve an IP address for a client that is connected to your
extender. Once reserved, the IP address will only be assigned to the same client by the
DHCP server.
Set the DHCP server
1. Tap DHCP Server
2. The Enable DHCP Server
be turn on or off according to the DHCP settings of the host network.
If you select On, please configure it manually.
• IP Address Pool: The start address and end address must be on the same subnet
with LAN IP. Your extender will assign addresses within this specified range to
its clients.
• Address Lease
current dynamic IP address assigned by your extender. After the dynamic IP
address expires, the client will be automatically assigned a new dynamic IP
address.
• Default Gateway
• Primary/Secondary DNS
ISP.
If you select Off, please make sure the DHCP server of your host network is on.
Otherwise, you have to set the IP address for each client manually.
3. Tap Save.
View the client information
Tap DHCP Server on the menu screen, then select
details of the clients connected to the extender are displayed as shown below.
Reserve an IP address
1. Tap DHCP Server
Add.
on the menu screen, then select
is set to be Auto by default, and the function will automatically
Time: The amount of time in which a DHCP client can lease its
(Optional): Enter the LAN IP address of your extender.
(Optional): Enter this parameters as provided by your
on the menu screen, then select
Further Configuration
DHCP Server.
DHCP Client List. On this page, the
Address Reservation and tap
23