Advertisement
2.5" HDD Enclosure
User's Manual
Introduction .................................................................................................. 2
Important Reminders for all Enclosures ....................................................... 2
Getting Started ............................................................................................. 3
Assembling the 2.5" HDD Enclosure............................................................ 4
Connecting the Enclosure to a Computer .................................................... 7
Notices and Classifications .......................................................................... 9
Advertisement
Table of Contents
Related Manuals for Dat Optic Speedzter II
Summary of Contents for Dat Optic Speedzter II
-
Page 1: Table Of Contents
2.5” HDD Enclosure User’s Manual Introduction ....................2 Important Reminders for all Enclosures ............2 Getting Started ..................... 3 Assembling the 2.5” HDD Enclosure............4 Connecting the Enclosure to a Computer ............ 7 Notices and Classifications ................9... -
Page 2: Introduction
Introduction Thank you for purchasing the 2.5” HDD Enclosure Kit. Your 2.5” HDD enclosure enables blazing fast data transfer speed and instant addition of external storage capacity. Simply complete the installation process to begin using your enclosure. Please thoroughly read and follow the instructions provided in this manual. -
Page 3: Getting Started
Getting Started The installation instructions in this manual apply to the following models. Please review the package contents for each model: IDE Hard Disk Enclosure USB2.0/FireWire HDD Enclosure Package Contents • Enclosure x 1 • USB-A to mini B cable x 1 •... -
Page 4: Assembling The 2.5" Hdd Enclosure
Macintosh Macintosh PowerPC processor Mac OS 9.X or newer One available USB port and/or IEEE 1394(b) port depending on model Notes: Use of the HDD enclosure via USB 2.0 requires Mac OS X 10.1.5/10.2.X with USB 2.0 driver installed, or Mac OS 10.2.8 or newer. Mac OS 9.X only supports full speed USB. - Page 5 3) Carefully slide the bottom panel out of the enclosure housing. Remove the screw from the control board by loosening the plastic caps. 5) Gently slide the Hard Drive into place. 6) Fasten the hard drive to the base using a Phillips screwdriver and the (4) screws included in the package.
- Page 6 7) Align the edges of the hard drive platform with the integral rails and carefully slide the assembled platform into the enclosure housing. 8) Ensure that the LED indicator is properly aligned with the opening on the front panel of the enclosure. 9) Reassemble the enclosure by replacing the (2) screws removed in step 1.
-
Page 7: Connecting The Enclosure To A Computer
OK!! Connecting the Enclosure to a Computer Complete the following steps to connect the enclosure to a host computer. Connect the AC/DC power adapter; ensure that the green LED indicator is active. The LED indicator will blink during data transfer. Insert the USB or IEEE 1394(b) connector into the corresponding port. - Page 8 Notes: 1) Any cable (FireWire, FireWire800, or USB 2.0) inserted before the enclosure is powered on has priority over the other cables and will be the primary connection method, i.e.: If the enclosure is connected via FireWire 800 before powering on the enclosure, data will be transferred via FireWire800.
-
Page 9: Notices And Classifications
Notices and Classifications FCC-B Radio Frequency Interference Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the Speedzter II and is the answer not in the manual?
Questions and answers