Table of Contents
Advertisement
Do not immerse the supply cord in water or other
liquids. If you are using the kettle for the first time,
it is recommended that you clean it before use by
boiling a full kettle of water twice and discarding
the water.
USING YOUR INSTANT
KETTLE
1.
To fill the kettle, remove it from the power
base and open the lid by pressing Lid relea-
se button, fill the water tank with the desired
amount of water, and then close the lid. The
water level must be within the Min and the
Max level. Too little water will cause the ket-
tle switching off before the water has boiled.
The max capacity of the kettle is 1.5L.
Do not add water over the maximum le-
vel, as it may spill out of the spout when boi-
ling. Ensure that the lid is firmly in place befo-
re connecting the plug into a power outlet.
Ensure that the lid is firmly in place be-
fore plugging into power outlet.
2.
Position the kettle on the power base. Make
sure it is positioned properly.
3.
Place your cup on the drip tray grille. Make
sure it aligns with the spout.
When to choose the size of cup, it is re-
commended the capacity of the cup
shall not be less than 250ml as the water ou-
tput from spout is set 250ml for one cup by the
system. Make sure the cup is positioned in
place before using.
4.
Connect the plug into power outlet, press
down the Power switch and its indicator will
light up, then start to boil the water.
5.
After a while, hot water will flow out from the
spout, and after a while the Power switch will
be off automatically and its indicator will go
out.
Before removing cup, make sure water
is not to flow out any more.
During boiling, the operation can be
stopped by pressing the Stop button at
any time, while the indicator will go out.
The water flowing out from spout is very
hot, handle carefully and never touch it
with hand to avoid scalding.
6.
ìIf you want to boil water again, only press
down the Power switch again to restart the
kettle.
7.
The kettle may be stored on the power base
when not in use. Always disconnect the po-
wer supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate wi-
thout water, the boil-dry protection will automati-
cally switch off the power. If this occurs, allow the
kettle to cool down before filling with cold water.
CLEANING AND
MAINTENANCE
Always disconnect the appliance from the power
outlet before cleaning.
1.
Never immerse the kettle, power cord or po-
wer base in water and never allow moisture
to get in contact with these parts.
2.
Wipe the outside of the body with a damp
cloth or cleaner. Never use a poisonous cle-
aner.
3.
Remember to clean the filter on a regular
basis. For easier cleaning, detach the filter
by pressing it down directly. Then replace it
after cleaning.
Do not use chemical, steel, wooden or
abrasive cleaners or brushes to clean
the outside of the kettle to prevent any gloss
loss.
EMPTYING YOUR KETTLE
1.
After your kettle has completely cooled
down, unplug it from the mains supply so-
cket.
2.
Press the Lid release button and hold your
kettle sideways over a sink. Then, tip your
kettle upside down.
en
7
Advertisement
Table of Contents
