Table of Contents
Advertisement
en
personal injury, do not immerse the cord, electric
plugs or kettle in water or other liquids.
•
While the water is boiling or just after the water
has boiled, avoid any contact with the steam.
•
Always take care to pour boiling water slowly
and carefully without tipping the kettle too fast.
•
Be careful when refilling a hot kettle.
•
The attached base cannot be used for any other
purpose than its intended use.
•
Extreme caution must be used when moving an
appliance containing hot water.
•
The use of accessory attachments that are not
recommended by the appliance manufacturer,
may result in fire, electric shocks or personal
injury.
•
Unplug the kettle from the outlet when not in
use and before cleaning. Allow the kettle to cool
down before installing / removing any parts and
before cleaning it.
•
This appliance has a built-in grounded plug.
Make sure the wall outlet in your house is
properly earthed.
•
Do not use the appliance for any other purpose
than its intended use.
•
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been provided supervision or instructions on the
use of the appliance by a person responsible for
their safety.
•
Always make sure that the appliance is in good
working order and that all its removable parts are
secure. Regularly check the power supply cord
and plug for cuts or damage.
•
Be sure your hands are completely dry before
touching the switch.
•
Risk of scalding: the kettle gets hot during use.
Therefore use only the handle to pick it up and
open the lid only after the kettle has cooled down.
•
Do not use it near the water in bathtubs, sinks or
other containers.
•
Only fill the kettle with water. Milk and instant
beverages will burn and damage the appliance.
•
The kettle can only be used with the stand
provided.
BEFORE FIRST USE
Carefully wipe the outside of the appliance to remove
any dust that may have accumulated. Dry with a dry
cloth. Do not immerse the supply cord in water or other
liquids. If you are using the kettle for the first time, it is
4 4
recommended that you clean it before use by boiling a
full kettle of water twice and discarding the water.
OPERATION OF YOUR KETTLE
Use the kettle only with its included base.
1.
To fill the kettle, remove it from the power base
and open the lid by pressing the lid opening
button, fill with the desired amount of water, and
then close the lid. Alternatively, the kettle may be
filled through the spout. The water level should
not exceed the max marks or sit below the min
level. Too little water will cause the kettle to switch
off before the water has boiled.
The max capacity of the kettle is 1.7L. Do not
add water over the maximum level, as it may
spill out of the spout when boiling. Ensure that the
lid is firmly in place before connecting the plug into
a power outlet.
2.
Position the kettle on the power base.
3.
Connect the plug into a power outlet. Press down
the switch: the indicator in the water gauge will
light up. Then start boiling the water. The kettle
will switch off automatically once the water has
boiled.
4.
Lift the kettle from the power base and then pour
the water.
5.
The kettle will not boil again until the switch is
pressed again. The kettle may be stored on the
power base when not in use.
Ensure that the switch is free of obstructions
and the lid is firmly closed. The kettle will not
turn off if the switch is constrained or if the lid is
open.
Be careful when pouring the water from your
kettle as boiling water may cause scalds. Do
not open the lid while the water in the kettle is hot.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without
water, the boil-dry protection will automatically switch
off the power. If this occurs, allow the kettle to cool
down before filling with cold water.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet
before cleaning.
Advertisement
Table of Contents
