Registrar Profiles - TELES VoIPBox DSL Reference Manual

5 Configuration files
5.3.4

Registrar Profiles

Registrar profiles are used to register the VoIPBox with a SIP registrar. It is possible to config-
ure different registrars for different destinations and to define backup registrars. These regis-
trar profiles are then assigned to the VoIP profiles:
route.cfg
Table 5.20 : Registrar Parameters
Registrar Parameters
[Registrar=<name>]
The name of the registrar profile.
RegId=<name or ip addr>
Host name or IP address used in the register's request header. Bear in mind that the DNS service
must be active if you enter the host name.
RegOwnId=<name@ip addr/domain>
Typically a host name or telephone number followed by an @ sign and a domain name or IP ad-
dress. The entry used in the
RegSameCallID=<mode>
When Yes is set (default), the same caller ID is always used for SIP registration. Set No to change
the caller ID for each SIP registration.
RegContact=<name or ip addr>
Used in the
RegContactParam=<string>
Sets additional header-parameters in the contact field (e.g.the q-value: RegContact-
Param=q=1.0).
RegUser=<name>
Enter a username for authorization.
RegPwd=<password>
Enter a password for authorization.
RegProxy=<ip addr>
Enter an alternative IP address if you want the request to be sent to an address other than the
one entered in
RegExpires=<sec>
Enter the number of seconds registration is to be valid. Default 0 means infinite.
RegPing=<sec>
Interval (in seconds) for the registrar ping. The VoIPBox sends an empty UDP packet to the regis-
trar's IP address. The packet is essentially an alive packet to avoid possible firewall problems.
RegSignalling=<int>
Determines the profile's signaling protocol for registration with the SIP registrar.
1=SIP udp (default)
2=SIP tcp
3=SIP tls
RegUseReceived=<mode>
Enter Yes when an VoIPBox appears behind a NAT and STUN cannot be used. Default No.
RegSameCallID=<mode>
The same call ID is used for SIP registration Enter No to change the call ID for every reregistration.
(default Yes).
VoIPBox DSL / VoIPBox BRI – version:20.0.005
From:
field. The default setting is
Contact:
field.
RegId .
RegUser@RegId
.
Page 55