Lennox Hearth Products LSM40-2 Installation Instructions

LENNOX HEARTH PRODUCTS
INSTALLATION INSTRUCTIONS FOR DECORATIVE SCREEN KITS FOR USE WITH MONTEBELLO
DAVE LENNOX SIGNATURE COLLECTION MODELS LSM40-2 & LSM45-2 DIRECT VENT GAS FIREPLACES
Kit Contents:
1 Ea. Screen Assembly
2 Ea. Short Spacers
2 Ea. Bottom Legs
4 Ea. Nuts
2 Ea. Long Screws
2 Ea. L- Brackets
2 Ea. Short Screws
1 Ea. Instruction Sheet
2 Ea. Long Spacers
Kit Contents
(dual arch screen shown)
Instruction Sheet
LENNOX HEARTH PRODUCTS
KITS AND ACCESSORIES
750,184M REV. A H2229 DASK-LSM40 Dual Arch Screen Kit, LSM40-2
04/2006
H2230 SK-LSM40 Screen Kit, LSM40-2
H2231 ASK-LSM40 Arch Screen Kit, LSM40-2
H2232 DASK-LSM45 Dual Arch Screen Kit, LSM45-2
H2233 SK-LSM45 Screen Kit, LSM45-2
H2234 ASK-LSM45 Arch Screen Kit, LSM45-2
INSTALLATION INSTRUCTIONS FOR DECORATIVE SCREEN KITS FOR USE WITH MONTEBELLO ®
DAVE LENNOX SIGNATURE SERIES MODELS LSM40-2 & LSM45-2 DIRECT VENT GAS FIREPLACES
Kit Contents: Tools Required:
WARNINGS
1 Ea. Screen Assembly 7/32" Allen Wrench
2 Ea. Bottom Legs 7/16" Nut Driver Hot! Do not touch! These decorative screen
2 Ea. Long Screws
panels are NOT heat guards. The glass behind the
2 Ea. Short Screws
2 Ea. Long Spacers screens will be hot during operation and will retain
2 Ea. Short Spacers
heat for a while after shutting off the appliance.
4 Ea. Nuts Severe burns may result. Carefully supervise
2 Ea. L- Brackets
1 Ea. Instruction Sheet children in the same room as appliance.
• As with any similar heating appliance, surfaces of the
Chain frame, the door and appliance can become very hot.
Kit Contents
(dual arch screen shown)
Instruction Sheet
INSTALLATION INSTRUCTIONS
Screen
750,184M REV. NC 3/2005 H2229 DASK-LSM40 SK-LSM40 H2230 LENNOX HEARTH PRODUCTS KITS AND ACCESSORIES Dual Arch Screen Kit, LSM40 Screen Kit, LSM40 Assembly
DAVE LENNOX SIGNATURE SERIES MODELS LSM40 & LSM45 DIRECT VENT GAS FIREPLACES INSTALLATION INSTRUCTIONS FOR DECORATIVE SCREEN KITS FOR USE WITH MONTEBELLO DASK-LSM45 ASK-LSM45 SK-LSM45 H2234 ASK-LSM40 H2233 H2232 H2231 Screen Kit, LSM45 Arch Screen Kit, LSM40 Dual Arch Screen Kit, LSM45 Arch Screen Kit, LSM45 Step 1 Using a 7/32" allen wrench and 7/16" nut driver, loosely assemble Short
2 ea. long spacers 1 ea. Screen Assembly 2 ea. long screws 2 ea. short screws 2 ea. short spacers Kit Contents: 7/16" Nut Driver 7/32" Allen Wrench Tools Required: INSTALLATION INSTRUCTIONS Step 1 Using an 7/32" Allen Wrench and 7/16" Nut Driver, loosely as- Step 2 Adjust the L-Bracket to height needed for this installation (slot tighten yet). semble the parts as shown in Figure 1 and Figure 2 (do not the parts as shown in Figure 1 and Figure 2 (do not tighten yet).
2 ea. L- brackets 4 ea. nuts Instruction Sheet 1 ea. Instruction Sheet Assembly Screen Step 3 Place the assembled freestanding screen in front of the fi replace when in use, in a close proximity to the glass door assembly. allows up to 1 inch vertical adjustment). When you are satisfi ed that the screen will stand stable in front of the fi replace, then tighten the nuts on both sides (snug only - do not over tighten). Side View Assembly
short spacers short screws Nuts Front Side Long Spacers Screen Assembly Fireplace Side Completed Short
Figure 1 - Kit Contents (dual arch screen shown) Long Screws Contoured Legs Long Spacers L- Brackets Figure 2 - Assemble Legs & L-Brackets to Screen Contoured Leg Short Spacers Nuts L- Bracket Spacers Step 2 Adjust the L-bracket to the height needed for this installation (slot
GENERAL INFORMATION enhance the beauty of the fi rpleplace and to provide some protection from These optional decorative freestanding fi rescreen panels are designed to any accidental contact with the hot glass surface.
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and the discontinuance of colors, styles and products. Consult your local distributor for fi replace code information. Figure 3 - Screen Styles NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Dual Arch Screen Screen Arch Screen allows up to 1 inch vertical adjustment). When you are satisfi ed
Printed in U.S.A. © LENNOX HEARTH PRODUCTS 2005 P/N 750,184M REV. NC 3/2005 Page 1 of 1 LENNOX HEARTH PRODUCTS Orange, CA 92865 1110 West Taft Avenue that the screen will stand stable in front of the fi replace, then
tighten the nuts on both sides.
Short Screws
Nuts
Contoured Legs
Side View
Spacers
Long Screws
L- Brackets
Long Spacers Chain Assembly
Completed
Screen
Assembly
Front Side Fireplace Side
Long Spacer
Dual Arch Screen Screen Arch Screen Short Spacer
Figure 1
GENERAL INFORMATION Nut
These optional decorative freestanding fi rescreen panels are designed
to enhance the beauty of the fi replace and helps prevent direct human L- Bracket
Contoured Leg
contact with the hot glass surface.
A chain is also provided for additional safety. When attached to the Figure 2 - Assemble Legs & L-Brackets to Screen
fi replace, it helps prevent the screen from tipping.
1
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Short Screws
Contoured Legs
Long Screws
Dual Arch Screen
Figure 1
GENERAL INFORMATION
These optional decorative freestanding fi rescreen panels are designed
to enhance the beauty of the fi replace and helps prevent direct human
contact with the hot glass surface.
A chain is also provided for additional safety. When attached to the
fi replace, it helps prevent the screen from tipping.
Tools Required:
7/32" Allen Wrench
7/16" Nut Driver
Chain
Screen
Assembly
Nuts
L- Brackets
Long Spacers
Screen Arch Screen
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
750,184M REV. B H5051 DASK-LSM40-2 Dual Arch Screen Kit, LSM40-2
05/2006
H5052 SK-LSM40-2
H5053 ASK-LSM40-2
H5054 DASK-LSM45-2 Dual Arch Screen Kit, LSM45-2
H5055 SK-LSM45-2
H5056 ASK-LSM45-2
Hot! Do not touch! These decorative screen
panels are NOT heat guards. The glass behind the
screens will be hot during operation and will retain
heat for a while after shutting off the appliance.
Severe burns may result. Carefully supervise
children in the same room as appliance.
• As with any similar heating appliance, surfaces of the
frame, the door and appliance can become very hot.
INSTALLATION INSTRUCTIONS
Step 1 Using a 7/32" allen wrench and 7/16" nut driver, loosely assemble
the parts as shown in Figure 1 and Figure 2 (do not tighten yet).
Step 2 Adjust the L-bracket to the height needed for this installation (slot
allows up to 1 inch vertical adjustment). When you are satisfi ed
that the screen will stand stable in front of the fi replace, then
tighten the nuts on both sides.
Screen
Assembly
Front Side
Long Spacer
Short Spacer
Contoured Leg
Figure 2 - Assemble Legs & L-Brackets to Screen
LENNOX HEARTH PRODUCTS
KITS AND ACCESSORIES
Classic Screen Kit, LSM40-2
Arch Screen Kit, LSM40-2
Classic Screen Kit, LSM45-2
Arch Screen Kit, LSM45-2
WARNINGS
Chain
Assembly
Completed
Fireplace Side
Nut
L- Bracket
Side View
®
1