Panasonic AJ-HD3700H Supplemental Operating Instructions page 11

TC/CHR menu
∑ Changing the superimposing position
∑ Time code displays and VTR's operating modes
Display the time codes and VTR's operating modes as required.
Time code displays
CTL1: Control signal 1
CTL2: Control signal 2
LTCR: LTC time code readout value
LUBR: LTC user bit readout value
VTCR: VITC time code readout value
VUBR: VITC user bit readout value
≥The colon (":") between the seconds and frames denotes the readout mode of the time code
reader.
Hours Minutes Seconds Frames
;
This indicates that the time code is the original time code which was recorded on the tape.
If the time code displayed is not accompanied by this cassette mark, it means that the time
code is the post-conversion time code. (This display will go off when setting the CTL or UB.)
ONoteN
∑ 2-step display pattern with Time code setting
Upper 10:04:24:29
Lower 10:04:24:23
The converted time code is always displayed on the upper position, and the original or converted time code is
displayed on the lower position by selecting the time code.
The following pattern below is displayed by selecting the F11 or F12 key on the TC/CHR CONVERT menu.
1080/23p (psf),
1080/24p (psf) formats
TC with frame count of 30
TC with frame count of 24
Or
TC with frame count of 30
TC with frame count of 30
(1) Move the position using the cursor keys.
≥When a cursor key is held down, the cursor will move more
quickly.
≥When the center cursor key is pressed, the superimposing re-
turns to its initial position.
; ; ;
<
Blinking display: Time code cannot be read out.
[ ]: First field
[. ]: Second field
[: ]: Time code can be read out or TCG value is displayed.
[ ]: Time code cannot be read out.
[. ]: DF mode ON
[: ]: DF mode OFF
1080/25p (psf),
1080/50i formats
TC with frame count of 25
TC with frame count of 24
Or
TC with frame count of 25
TC with frame count of 25
– 11 –
Cursor keys
TCG: Value generated by time code generator
LUBG: Value of LTC user bit generated
VUBG: Value of VITC user bit generated
EXTC: External time code value
EXUB: External user bit value
Other formats
Original TC with frame count of 30
Original TC with frame count of 30
Center cursor key