Table of Contents
Advertisement
3. Connect the white RS232 cable, the right-angled power chord, and the black HDMI cable to the projector
before mounting it into place.
4. Carefully place the projector in the printer box so the 3 hex screws (M3x14mm) align with the projector
mountings and use the 2.5mm L-shaped Allen Wrench to screw the projector into position (Do Not over
tighten the hex screws).
Note: Make sure the hex screws are in the middle of the slot.
Kudo3D Titan 1 - Build Manual
Ver. 1.1
18 of 33
Advertisement
Table of Contents
