Installing The Circuit Board - Kudo3D Titan 1 Build Manual

C. Installing the Circuit Board
1. Using the 3mm T-ball Headed Allen wrench (Orange handle), loosen (Do not completely unscrew) the 4
hex screws (3mm) holding up the circuit board mounting plate, raise it past the midpoint of the printer box,
and tighten the screws again.
2. Locate the aluminum heat sink in the anti-static circuit board parts pack and carefully place the heat sink
over the small black chip of the red A4988 driver board.
Kudo3D Titan 1 - Build Manual
Ver. 1.1
15 of 33