Table of Contents
Advertisement
10
1.
To avoid the system instability after clearing CMOS, we recommend
users to enter the main BIOS setting page to "Load Optimized Defaults"
and then "Save & Exit Setup".
2. Make sure the power supply provides enough 5VSB voltage before se-
lecting the 5VSB function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto
2-3 pin rather than 1-2 pin as default if you want to wake up the com-
puter by USB/PS2 KB/Mouse.
Connecting Case Components
After you have installed the motherboard into a case, you can begin connecting the
motherboard components. Refer to the following:
1
Connect the CPU cooling fan cable to CPU_FAN.
2
Connect the system cooling fan connector to SYS_FAN.
3
Connect the case switches and indicator LEDs to the F_PANEL.
4
Connect the standard power supply connector to ATX_POWER.
5
Connect the auxiliary case power supply connector to ATX12V.
6
Connec the case speaker cable to SPK.
Connecting 24-pin power cable
Users please note that the 24-pin power cable can be connected to the
ATX_POWER connector.
24-pin power cable
With ATX v2.x power supply, users please
note that when installing 24-pin power
cable, the latches of power cable and the
ATX_POWER match perfectly.
Installing the Motherboard
Hide quick links:
Advertisement
Table of Contents
