Fishman C-100 User Manual page 5

4. Once the transducer is properly inserted into the
bridge, the next step is to mount the adhesive-backed
jack mount to the back side of the tailpiece. First, peel
off the release fi lm from the holder and then press the
holder fi rmly in place below the fi ne tuning machines
of the tailpiece. Position the holder so that the jack,
when slipped into the holder, will be at a right angle
(90°) to the tailpiece.
5. Insert the jack into the holder and snap shut. Since the
wire is somewhat microphonic, it should not be allowed
to lie on the face of the instrument.
5