Janome MC8200QC Instruction Book page 28

q
w
e
Needle stop position setting
The machine always stops with the needle in the down
position except when sewing buttonholes, specialty
stitches, monograms, etc. However you can select the
needle stop position to up or down.
Enter the setting mode. Press the MODE key to enter
the needle stop position setting.
The default needle stop position setting is down position
"dn".
To change the needle stop position, press the cursor
key "
Press the set key to exit the machine setting mode.
Start-up speed setting
The machine will start running slowly and the sewing
speed will gradually increase to maximum when pressing
the start/stop button.
You can select the desired start-up speed from 1 (slow) q,
2 (medium) w or 3 (high) e.
Enter the setting mode. Press the MODE key twice to
enter the start-up speed setting.
The default start-up speed setting is "1" (slow). To change
the start-up speed, press the cursor key "
" ", and the selected speed number will blink.
Press the set key to exit the machine setting mode.
Resetting all to default
The following customized settings can be reset to the
original settings (factory settings).
• Buzzer sound
• Needle stop position
q
• Start up speed setting
Enter the setting mode. Press the MODE key 3 times to
enter the Resetting all to default mode.
Press and hold the clear key q until the machine beeps
to reset the machine to the factory default setting.
Press the set key to exit the machine setting mode.
26
" and the "UP" mark will blink.
" or