LG GX300 Service Manual page 59

3. TECHNICAL BRIEF
3.13.2 Digital Part
The digital part of the X-GOLD™213 audio front-end comprises an interface to the TEAKLite® bus,
interfaces to the interrupt units of TEAKLite®, digital interpolation filters for oversampling digital-to-
analog conversion, digital decimation filters for analog-to-digital conversion and an interface to the
analog part of the audio front-end. For the digital microphone all the filtering is done in a dedicated
hardware. The output sample stream is then fed in a duplicated ring buffer structure like the data from
the analog microphone path (after A/D conversion and subsequent digital filtering).
Interpolation Filter
The interpolation path of the X-GOLD™213 audio front-end increases the sampling rate of the audio
samples to the rate of the digital-to-analog converter. Because the input sampling rates can vary
between 8 kHz and 47.619 kHz the filter characteristic and oversampling ratio can be adjusted to the
respective sampling rate. The requirements for the interpolation filters depend on the sampling rate,
because a sufficient out-of-band discrimination in the audio frequency band (20 Hz,...,20 kHz) has to be
ensured.
Decimation Filter
The digital decimation filter on X-GOLD™213 has two operating modes: 8 kHz output sampling rate and
16 kHz output sampling rate (or 16 kHz output sample rate and 16kHz bandwidth in case of doubled
ASMD clock).
3.13.3 Analog Part
The analog part of the X-GOLD™213 audio front-end in audio-out direction consists of a stereo digital to
analog converter (multi-bit oversampling converter) which transforms the output of the digital
interpolation filter into analog signals. It is followed by the gain control/amplifier section. The DAC
outputs can be switched to several output buffers. In audio-in section there is an input multiplexer
which selects either one of two differential microphone inputs to be connected to the low-noise
amplifier and analog pre-filter. The signals from the analog pre-filter are input to a second-order sigma-
delta analog-to-digital converter. In addition there is a connection for FM-radio playing.
Audio-out Part
The analog audio-out part consists of two multi-bit digital-to-analogue converters (DAC) and an output
stage. The signal sources are switched to the output drivers in the output stage. The output drivers
consist of: a) one mono, differential class-D Loudspeaker driver, b) one mono, differential Earpiece
driver and c) one stereo, single-ended (with uni- or bipolar signals), Headset driver.
LGE Internal Use Only
60/158
- 60 -
Copyright © 2010 LG Electronics. Inc. All right reserved.
3. TECHNICAL BRIEF
Only for training and service purposes