Download Print this page

Getting Started - Braun Satin-Hair 7 CU 710 User Manual

Hide thumbs Also See for Satin-Hair 7 CU 710:

Advertisement

English
Please read these use instructions carefully before use and keep
them for future reference.
Important
• Plug your appliance into an alternating current ( ) outlet only
and make sure that your household voltage corresponds to the
voltage printed on the appliance.
This appliance must never be used near water (e.g. a
filled wash basin, bathtub or shower). Do not allow the
appliance to get wet. Always unplug it after use.
• For additional protection, it is advisable to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30 mA in the electrical circuit of your bathroom.
Ask your installer for advice.
• This appliance is not intended for use by children or persons
with reduced physical, sensory or mental capabilities unless
they are given supervision by a person responsible for their
safety.
• Keep out of reach of children.
• Be careful to avoid that the hot surfaces of the appliance get
into direct contact with the skin, in particular of the ears, face
or neck.
• When hot, do not place on surfaces that are not heat-resistant.
• Do not wrap the mains cord around the appliance. Regularly
check the mains cord for wear of damage. If the cord is
damaged, stop using the appliance.
• If the complete display flashes, this indicates an internal error
of the appliance. In this case, take the appliance to a Braun
Service Centre for checking. Unqualified repair work can lead
to extreme hazards for the user.
• The appliance should be used on dry hair only.
Description
1 Cool tip
2 Tong with clamp
3 Green ion jet
4 Tong opener
5 LC Display
6 Temperature selector (– / +)
7 satin ions button
8 On/off button
9 Swivel cord

Getting started

• Connect the appliance to an electrical outlet and push the on/
off button [8] for 1 second to turn it on.
• During heat-up, the display shows three flashing segments
(Fig. A).
• After approximately 45 seconds, the minimum styling tempera-
ture is reached and you can start using the appliance.
• Using the temperature selector [6], you can adjust the styling
temperature. There are 5 temperature levels represented by
ascending segments on the display. When changing the tem-
perature, the segments will flash. The segments shine perma-
nently when the selected temperature is reached.
• We recommend the following temperature settings:
1 segment (min):
2 to 4 segments:
5 segments (max): for thick hair and professional use (Fig. C)
The higher the temperature, the better the curling result will be.
However, for better care of chemically treated hair, the tem-
perature setting should be 3 segments maximum.
IONTEC
IONTEC is a technology which is specifically developed to
protect the health of your hair. It restores the moisture balance of
your hair that usually gets lost during styling with excessive heat.
By activating the satin ions button [7] for one second, the green
ion jet [3] releases millions of ions effectively on to your hair.
These satin ions envelop every single hair and quickly restore the
moisture balance of your hair by attracting moisture particles
from the air while curling.
7
for fine hair (Fig. B)
for normal hair

Advertisement

loading