1-1. REAR COVER REMOVAL
1
Remove 20 screws from Rear Cover
2
Remove 1 screw from Side Jack position
3
Remove 1 screw from Terminal position
4
Remove 4 screws from Rear Cover
5
Remove 4 screws from Rear Cover
NOTE: The Rear Cover is attached to the Bezel Assembly with three small tabs.
Use caution when removing the Rear Cover not to damage these tabs.
1-2. SWITCH UNIT REMOVAL (CONTAINS HSW3 BOARD)
1
Lift up the bottom of Switch Unit from Bezel and unhook from Bezel
2
Disconnect 1 connector from HW3 Board
KDL-52S5100/52V5100
SECTION 1: DISASSEMBLY
1
Bezel
2
Switch Unit (Contains HSW3 Board)
KDL-52S5100/52V5100
13