Miele FN 12221 S Operating And Installation Instructions page 46

Changing the door hinging
^ Open the door.
^ Holding the door at the bottom and
on the handle side, carefully lift it
upwards and off.
This will release hinge pin e with
washer o out of hinge plate d. If it
does not release:
^ Press hinge pin e with washer o out
of the hinge plate from below.
46
^ Undo screws f and take hinge plate
d off.
^ Undo the screw of hinge part g on
hinge plate d slightly. Fit it into the
hole opposite in hinge plate d and
tighten up the screw.
^ Remove plug h and place it in the
opposite hole in the hinge plate.
^ Remove cover i.
^ Unscrew and remove screw j and
refit it into the outer hole of the
opposite side.
^ Turn cover i through 180°, and fit it
into the holes on the other side.
^ Screw hinge plate d into position on
the opposite side using the two outer
long slots only. Do not use the middle
hole because you will not be able to
align the door later on.