Marshall Amplification TSL100 User Manual page 10

Rear Panel - TSL122 Combo
MAINS INPUT
MAINS FUSE HT FUSE EMULATED
120V ~ 60 Hz
(T2A - 230V) T1A LINE OUT
375 Watts
(T4A - 120V)
Made in England by:
Marshall Amplification plc, Bletchley, Milton Keynes, England.
6
Rear Panel - TSL100 Head
CAUTION!:
TO REDUCE THE RISK OF FIRE REPLACE FUSES WITH THE SAME TYPE
AND RATING ONLY. DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ATTENTION!:
POUR EVITER LES RISQUES D'INCENDIE UTILISER UN FUSIBLE DE
MEME TYPE ET DE MEME CALIBRE. DEBRANCHER AVANT DE REMPLACER LE FUSIBLE.
POUR EVITER LES RISQUES DE DECHARGES ELECTRIQUES, NE PAS OUVRIR LE
COUVERCLE. CET APPAREIL NE COMPORTE AUCUNE PIECE SUSCEPTIBLE D'ETRE
REPAREE PAR VOS SOINS. FAITES TOUJOURS APPEL A UN TECHNICIEN QUALIFIE POUR
TOUTE REPARATION.
WARNING!:
SHOCK HAZARD. DO NOT OPEN. TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
THIS APPARATUS MUST BE EARTHED.
AVIS!:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR. POUR EVITER LES RISQUES
D'INCENDIE ET DE DECHARGES ELECTRIQUES, N'EXPOSEZ JAMAIS CET APPAREIL A
L'HUMIDITE OU A LA PLUIE. CONNECTER CET APPAREIL A LA TERRE.
Diagram D - Rear Panels
WARNING!: AVIS!:
RISK OF HAZARDOUS ENERGY! ENERGIE ELECTRIQUE DANGEREUSE!
!
LOUDSPEAKER OUTPUTS
8 Ohm 4 Ohm
SELECT (4 & 8 Ohm PARALLEL JACKS) 16 Ohm ONLY
Note: 16 Ohm Output Jack negates use of others.
REFER TO MANUAL FOR FULL DETAILS. SE REFERER AU MANUEL POUR PLUS DE DETAILS.
5 4 3
{ 1 - Use EFFECTS LOOP A only as Master Loop (on all three channels)
LOOP MODE 2 - Use EFFECTS LOOP B only for effects on OD channels (CRUNCH & LEAD) only
3 - Use EFFECTS LOOPS A and B for separate effects on CLEAN & OD channels
FOOT CONTROLLER EFFECTS LOOP A
LOOP LOOP
LEVEL LEVEL
SEND RETURN
1 2
EFFECTS LOOP B EFFECTS LOOP A
LOOP LOOP
LEVEL LEVEL
RETURN SEND RETURN
1 - Use EFFECTS LOOP A only as Master Loop (on all three channels)
{
LOOP MODE 2 - Use EFFECTS LOOP B only for effects on OD channels (CRUNCH & LEAD) only
3 - Use EFFECTS LOOPS A and B for separate effects on CLEAN & OD channels
2
WARNING!:
RISK OF HAZARDOUS ENERGY!
!
AVIS!:
ENERGIE ELECTRIQUE DANGEREUSE!
EFFECTS LOOP B LOUDSPEAKER OUTPUTS
SEND RETURN 16 Ohm ONLY (4 & 8 Ohm PARALLEL JACKS)
Note: 16 Ohm Output Jack negates use of others.
REFER TO MANUAL FOR FULL DETAILS. SE REFERER AU MANUEL POUR PLUS DE DETAILS.
3
CAUTION!:
TO REDUCE THE RISK OF FIRE REPLACE FUSES WITH THE SAME
FOOT CONTROLLER
TYPE AND RATING ONLY. DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ATTENTION!:
POUR EVITER LES RISQUES D'INCENDIE UTILISER UN FUSIBLE
DE MEME TYPE ET DE MEME CALIBRE. DEBRANCHER AVANT DE REMPLACER LE
FUSIBLE. POUR EVITER LES RISQUES DE DECHARGES ELECTRIQUES, NE PAS
OUVRIR LE COUVERCLE. CET APPAREIL NE COMPORTE AUCUNE PIECE
SUSCEPTIBLE D'ETRE REPAREE PAR VOS SOINS. FAITES TOUJOURS APPEL A
UN TECHNICIEN QUALIFIE POUR TOUTE REPARATION.
SEND
WARNING!:
SHOCK HAZARD. DO NOT OPEN. TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
THIS APPARATUS MUST BE EARTHED.
AVIS!:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR. POUR EVITER LES
RISQUES D'INCENDIE ET DE DECHARGES ELECTRIQUES, N'EXPOSEZ JAMAIS CET
APPAREIL A L'HUMIDITE OU A LA PLUIE. CONNECTER CET APPAREIL A LA TERRE.
1
Made in England by:
Marshall Amplification plc, Bletchley, Milton Keynes, England.
HT FUSE
EMULATED
T1A
LINE OUT
4 Ohm 8 Ohm
SELECT
4 5
MAINS INPUT MAINS FUSE
(T2A - 230V)
120V ~ 60 Hz
(T4A - 120V)
375 Watts
6