Page 1
OPAL 2011S The Teledex two-line conference telephone specifically designed for the international hospitality industry.
Page 2
CONNECTING THE OPAL 2011S 1. Located on the left side of the Opal 2011S (as the phone is facing you) is a modular jack. Insert one end of the coiled handset cord into this jack (you should hear the coil cord click when properly inserted).
Page 3
RECEIVING A CALL An audible ring and flickering red LED indicate an inbound call. USING THE HANDSET 1. Lift the handset. The Opal will select the ringing line. 2. To end the call hang up the handset. USING THE SPEAKERPHONE 1.
Page 4
ADJUSTING THE RING VOLUME Locate the respective “Line Ringing Volume” adjustment control on the back of the telephone labeled RINGER LOW/HI (see diagram on page 7). Slide the switch to the desired LOW or HI ring volume for each line. SPEAKERPHONE TIPS TO ACTIVATE THE HANDSET FROM SPEAKERPHONE MODE: 1.
Page 5
2. Flip the clip over (top to bottom) so that the protruding edge is towards the top of the phone. This edge will hold the handset. 3. Turn the Opal 2011S over so the bottom is up facing you. Place the Opal on a nonabrasive sur- face to prevent scratching.
Page 6
OPAL 2011S DIAGRAM MESSAGE WAITING LIGHT RING VOLUME MODULAR PHONE LINE JACK DATA PORT STORE KEY (RECESSED) AUTO DIAL KEYS SPEAKER VOLUME AUTO DIAL KEYS HANDSET VOLUME FLASH MUTE REDIAL AUTO DIAL KEY HOLD SPEAKER PHONE LINE 2 LINE 1...
Page 7
REQUIREMENTS OF PART 68 - FCC RULES This device has been granted a registration number by the Federal Communications Commission, under Part 68 rules and regulations for direct connection to the telephone lines. In order to comply with these FCC rules, the following instructions must be carefully read and applicable portions followed completely: 1.
Page 8
Teledex Corporation, 6311 San Ignacio Avenue, San Jose, CA 95119 www.teledex.com For Customer Service Call +408-363-3100 Part Number 606-2700-00...
Need help?
Do you have a question about the Opal 2011S and is the answer not in the manual?
Questions and answers