Table of Contents
Advertisement
Chapter XV Configure Controllers Manually
This chapter introduces how to use SANtticity storage management software to configure and
change IP addresses of controllers under the condition that there's no DHCP server.
15.1 Configuration notes
1. Please refer to content in Chapter V Select Management to decide whether to change
controller configuration.
2. Use Ethernet port 1 on each controller for storage management, and reserve Ethernet port
2.
3. Ethernet port 1 and Ethernet port 2 shall be in different subnets.
4. Gateway configuration could only be carried out on one Ethernet port on each controller.
15.2 Configuration steps
1. Use in-band management or private network (laptop connects to storage controller via
switch or direct connection) to initialize to find storage arrays (default management
addresses of controller A and B in IPv4 network are 192.168.128.101 and
192.168.128.102).
2. Open enterprise management window (EMW), double click storage arrays to be configured
in Device column, an array management window displays.
3. Click Logical/Physical column.
4. Select controller A in array management window (AMW) to highlight, and select
controller>>configure>>Management ports , as shown in the following figure,
Figure 15-1
Advertisement
Table of Contents
