Specifications - Sony TA-A1ES Operating Instructions Manual

Specifications

Amplifier section
POWER OUTPUT
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated
80 watts per channel minimum RMS power, with no more than 0.09 %
total harmonic distortion from 250 milliwatts to rated output.
Rated Power Output*
80 W + 80 W
20 Hz to 20 kHz 0.15 % 8 ohms
* Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
Supported impedance of speakers
4 ohms or higher
Distortion
0.008 %
1 kHz 10 W 8 ohms
Frequency response
10 Hz to 100 kHz ±3 dB (8 ohms)
Input (UNBALANCED)
Sensitivity: 150 mV
Impedance: 47 kohms
S/N ratio: 96 dB (Input short, A, 20 kHz LPF)
Input (BALANCED)
Impedance: 20 kohms / 20 kohms
S/N ratio: 96 dB (Input short, A, 20 kHz LPF)
Headphones amplifier section
Supported impedance
LOW: from 8 ohms to less than 50 ohms
MID: from 50 ohms to less than 300 ohms (+10 dB against LOW)
HI: 300 ohms or higher (+16 dB against LOW)
Distortion
0.1 % or less
20 Hz to 20 kHz
LOW (8 ohms load impedance) 500 mW + 500 mW
MID (150 ohms load impedance) 500 mW + 500 mW
HI (300 ohms load impedance) 250 mW + 250 mW
Frequency response
10 Hz to 100 kHz +0.5/–3 dB (at LOW mode 8 ohms load impedance)
General
Power requirements
120 V AC, 60 Hz
Power consumption
300 W
Power consumption (during standby mode)
0.4 W
Dimensions (Approx.)
430 mm × 130 mm × 420 mm (17 in × 5 1/8 in × 16 5/8 in) (w/h/d),
including projecting parts and controls
Mass (Approx.)
18.0 kg (39 lb 11 oz)
Supplied accessories
AC power cord (mains lead) (1)
Remote control RM-AAU181 (1)
R03 (size AAA) batteries (2)
Operating Instructions (this manual) (1)
Design and specifications are subject to change without notice.
21
US