Connecting The Ssc300; Connecting To Nmea 2000 Interface; Figure 3 - Nmea 2000 - Maretron SSC300 User Manual

SSC300 User's Manual

2.4 Connecting the SSC300

®
You have a choice of connecting the SSC300 to a NMEA 2000 interface (Section 2.4.1), NMEA
0183 interface (Section 2.4.2), or connecting both interfaces simultaneously (Section 2.4.2.2).
The SSC300 has two connection ports. Please use the M000102 Micro Cap which is shipped
installed on the NMEA 0183 connector to cover unused connectors.
NMEA 2000 / Power NMEA 0183 Connector
Connector
Figure 3 – NMEA 2000
®
/ NMEA 0183 Interface Connector Locations
®
2.4.1 Connecting to NMEA 2000 Interface
®
The Maretron SSC300 provides a connection to an NMEA 2000 interface through a five pin
®
male connector (Figure 4). You connect the SSC300 to an NMEA 2000 network using a
®
Maretron NMEA 2000 cable (or compatible cable) by connecting the female end of the cable to
the SSC300 (note the key on the male connector and keyway on the female connector) as shown
in Figure 5 below.. Be sure the cable is connected securely and that the collar on the cable
®
connector is tightened firmly. Connect the other end of the cable (male) to the NMEA 2000
network in the same manner. The SSC300 is designed such that you can plug or unplug it from
®
an NMEA 2000 network while the power to the network is connected or disconnected. Please
®
follow recommended practices for installing NMEA 2000 network products.
Page 6 Revision 1.0