Table of Contents
Advertisement
NOTE
You may be unable to raise the volume level if the
volume level of the external device is too low.
NOTE
○ When connecting a smartphone, please be aware that
the ringtones of incoming calls for some models are not
output to speaker.
○ External devices may be damaged if used in locations
exposed to the sun or hot temperatures.
○ See page 11 when recharging with USB in "
mode.
CONNECTING WITH BLUETOOTH
DEVICES
If smartphones, portable music players and other devices
are Bluetooth compatible, audio can be output from this
product via Bluetooth communication.
1. Pairing (Registering devices)
Pairing is required for Bluetooth communication.
Set your Bluetooth device to pairing mode.
(For instructions on pairing, see the manual for the
Bluetooth device to be used.)
2. Set the radio for pairing mode
Press the Source select button and display "
Bluetooth
Long press the Play / Stop button (located between
the Search buttons) until the displayed "
fl ashing.
(Long Press)
Select
"HITACHI_UR18DSDL"
device's list of connected devices to complete the pairing.
3. Input pass key
Some Bluetooth devices may require pass key input
when connecting.
If this should be the case, input "0000".
Also, if connection authorization is requested, input
"authorized".
Connection is successful once "
Connected
NOTE
○ Once
paired,
connection
established the next time the devices are switched on. If
the Bluetooth connection is lost, re-pair the devices.
○ No more than two devices can be paired simultaneously.
○ Connection with all Bluetooth devices cannot be
guaranteed. Before attempting connection, always
check for compatibility.
4. Playback
Make sure to lower the volume output of the Bluetooth
device before music playback.
Volume can be adjusted through the radio.
Use the Bluetooth device to select tracks .
You can also select tracks with the radio's control
buttons.
(Volume)
(Play / Stop, Search)
NOTE
○ Some Bluetooth devices may not respond to the radio's
control buttons.
○ See page 11 when recharging with USB in "
mode.
"
" .
" is
Ready
on
your
Bluetooth
" is displayed.
will
be
automatically
"
USING THE TIMER FUNCTION
● Setting the sleep timer
Power can be set to automatically switch OFF after a certain
amount of time has elapsed by using the sleep timer function.
1. Press the Menu button.
2. Press the Select button and display "
3. Press the Enter / Information button.
4. Press the Select button to adjust the time period to
elapse (between "0 – 90" minutes) before the power is
switched OFF.
5. Press the Enter / Information button.
6. "
" will be displayed on the LCD.
○ To check the remaining time, press the Menu button
once again and select "
○ To cancel the sleep timer, set the time to switch OFF at 0
minutes.
● Setting the alarm (Buzzer alarm)
The radio can be set up to activate a beeping alarm at a
specifi c time.
1. Press the Menu button.
2. Press the Select button and display "
3. Press the Enter / Information button.
4. Press the Select button and display "
5. Press the Enter / Information button.
6. Press the Select button and adjust "hour" digits.
7. Press the Enter / Information button.
8. Press the Select button and adjust "minute" digits.
9. Press the Enter / Information button.
10. Press the Select button to set up repeat.
Once
Daily
Weekdays only
Saturday and Sunday only
10
Sleep
30 Min
".
Buzzer alarm
".
ON
12 : 00
12 : 30
Daily
".
".
Advertisement
Table of Contents
