Table of Contents
Advertisement
5.
Loosen each gold thumb screw a few turns.
You do not have to remove the thumbscrews—just loosen them
enough to slide the leads of your resistor in the gap.
6.
Place the leads of resistor between thumb screws and ter-
minal posts.
7.
Tighten thumb screws firmly.
The result should look something like the photo below (although
your resistor may well look different).
8.
Trim lead if necessary to avoid contact with other compo-
nents.
Be careful to keep the trimmed lead wires from falling into the
phono module.
27
Advertisement
Table of Contents
