Advertisement
CYMBAL SETUP/CONNECTIONS
CONNECTIONS and SETTINGS
2 ZONE CRASH or RIDE CYMBAL
1. Connect one TRS Stereo cable from the OUTPUT jack to the CYMBAL or AUX input on
your sound module.
(OUTPUT) = TIP = BOW SOUND / RING = EDGE SOUND (or BELL SOUND if using a RIDE)
TRS Stereo Jack (OUTPUT)
TIP
RING
SLEEVE
BOW
EDGE
SOUND
SOUND
3 ZONE RIDE CYMBAL
1. Turn off 3-way triggering "if applies to your sound module"
2. Connect one TRS Stereo cable from the BOW/EDGE OUTPUT jack to the RIDE or AUX
input on your sound module. Assign the bow and edge sound you like to each zone.
See your owners manual for further details.
3. Connect another TRS Stereo cable from the BELL OUTPUT jack to the EDGE or AUX input
on your sound module. Assign the bell sound sound you like to the zone.
See your owners manual for further details.
(BOW/EDGE OUTPUT) = TIP = BOW SOUND / RING = EDGE SOUND
(BELL OUTPUT) = TIP =BELL SOUND
TRS Stereo Jack (BOW OUTPUT)
TIP
RING
SLEEVE
BOW
EDGE
SOUND
SOUND
NOTE:
If you wish to separate the output on the cymbal for two separate inputs on the sound
module, you must use a Ring to Tip Y adapter. The Y adapter is useful for using separate
sound module inputs on one cymbal. This is used for further zone isolation and sound
options.
TRS Stereo Jack (BELL OUTPUT)
TIP
RING
SLEEVE
BELL
SOUND
6
Advertisement
