Advertisement
ASSEMBLY:
Your FIELD hi-hat comes pre-assembled, no need for assembly. However if you choose to
disassemble and reassemble the hi hat or remove an re- install the hi hat clutch simply
losen the clutch wing nut and screw/unscrew clutch from hi hat controller. Be sure to use
the included felt spacers between internal controller and inside top hi hat bell.
1. Use a STANDARD style clutch and tighten top threaded nuts as far to the top of
clutch head as possible. Use included felt spacers for proper closed position
adjustment. (see fig A)
2. Screw clutch into internal threaded controller as shown. Connect top and bottom
cymbals via TRS phono jack. Make sure wires do not interfere with clutch and plunger.
(see fig B)
3. Top and Bottom Hi Hat should fully touch. Internal felt washers should be in contact
with inside top of hi hat bell and top of internal controller to achieve a closed sound
from you sound module. (see fig C)
Position the (FIELD Logo) so that it is facing away from the player for optimal triggering
response.
Use included felt spacers
(fig A)
for proper closed position
adjustment
(fig B)
Fully assembled view
(fig C)
HH CONTROL OUTPUT
Insert wires from sound module to appropriate Hi-Hat outputs to the bottom of Hi-Hat
H I - H A T A S S E M B L Y
Use a STANDARD style
clutch and tighten top
threaded nuts as far to the
top of clutch head as possible
Screw clutch into internal threaded
controller as shown.
Make sure to use the included felt spacers
for proper HH control closed position.
Top and Bottom Hi Hat should fully touch.
Internal felt washers should be in contact with inside
top of hi hat bell and top of internal controller to
achieve a closed sound from you sound module.
HH OUTPUT
Connect top and bottom cymbals via
TRS phono jack. Make sure wires do
not interfere with clutch and plunger.
4
USE STANDARD STYLE CLUTCH
DO NOT USE THIS STYLE CLUTCH
WITH A SET SCREW
Advertisement
