Table of Contents
Advertisement
26
Installing the Endurance Software
If your network will not use a CoServer Management connection, push
4.
Next without highlighting an adapter.
If you will be using CoServer Management, then on the Configure CoS-
erver Management page, highlight the adapter you wish to assign for
CoServer Management in the Connection column. Select the adapter
based upon the PCI location-to-switchbay mapping you established dur-
ing planning and preparation.
If you wish to assign an IP address, right click on the selection and
choose Internet Protocol Properties from the action menu. On the
Internet Protocol Properties page select Use the following IP
address, fill-in the appropriate address, enter the desired Subnet mask
and click OK. Click Next to continue.
Marathon Technologies Corporation
Advertisement
Table of Contents
