Visual Characteristics; Test Conditions; Display Dimensions - Philips C500 Service Manual

1 ON
2 STAND-BY
3 SUSPEND
4 OFF
The states of power saving function shall be display by LED indication.
2.9

Visual Characteristics

All factory preset resolutions must guarantee the right display dimension and centering. Other
resolutions can be adjusted correctly with the external controls as per section 2.5.
In all resolution must be possible to adjust the monitor in full screen (overscan mode) by external
controls. The viewing eye angle while performing any dimensional measurement is parallel to the axis
of the picture tube.

2.9.1 Test Conditions

Resolution:
Input level:
Pattern:
Brightness control:
Contrast control:
Unless otherwise specified, the display shall meet the requirements of this section under any
combination of the following operating ranges:
Image duty cycle:
Input power:
Operating
Humidity:
Magnetic field:

2.9.2 Display Dimensions

The dimensions of the data area for all presetting mode listed in part 2.3.1,measured along the
PLUSES PLUSES
NO PLUSES PLUSES
PLUSES NO PLUSES BLANKED
NO PLUSES NO PLUSES BLANKED
any of preset modes
700 mV
crosshatch after setting full white pattern with
20FL luminance.(Except otherwise indicated)
cutoff position
position after setting full white pattern with 20FL luminance.
10% to 90%
As per section 3.1
temperature: As per section 6.2
As per section 6.2
Horizontal=0 Gauss
Vertical=0.4 Gauss
ACTIVE
BLANKED
7
NONE
<15W@90~240VAC
<15W@90~240VAC
<5W@90~240VAC