Advanced Connecting; Connecting The Remote Control Jacks - Marantz R3001 User Manual

ADVANCED CONNECTING

FM (75Ω) GND AM
ANTENNA
L
R
IN OUT IN
CD TAPE CDR/MD
SUBWOOFER
OUT
L R L R
CENTER
L
R
SUB
FRONT SURR.
WOOFER
CONNECTING MULTI CHANNEL AUDIO SOURCE
The 7.1CH INPUT jacks are for multichannel audio
source such as a SACD multichannel player, DVD
audio player or external decoder.
If you use these jacks, switch on the 7.1CH INPUT
and set the 7.1CH INPUT level by using the 7.1
channel input level menu. See page 29.
14
VIDEO S
V
IN OUT
IN OUT IN OUT MONITOR VCR1 DVD MONITOR
DSS / VCR2 VCR1 DVD TV L L SL SL C C SBL SBL
OUT IN OUT IN OUT R R SR SR SW SW SBR SBR
DSS / VCR2 VCR1 DVD TV 7.1CH INPUT 7.1CH INPUT
AUDIO
R L R L R L
FRONT SURROUND BACK SURROUND CENTER
S. SPEAKER B
SPEAKER SYSTEMS 6 - 8 OHMS
L R L R R L
L R
SURR.
BACK
DVD Audio player
or
SACD Multi channel player

CONNECTING THE REMOTE CONTROL JACKS

RC-5 RC-5
S-
VIDEO
Y
IN OUT
MONITOR VCR1 DVD MONITOR IN IN OUT OUT
TV L SL C SBL
C B /
P B
C R /
P
R
R SR SW SBR 1 2 3
TV 7.1CH INPUT DVD DSS / VCR 2 MONITOR
DIGITAL INPUT COMPONENT VIDEO
R L R L
RROUND BACK SURROUND CENTER
. SPEAKER B
8 OHMS
1
REMOTE REMOTE
CD recorder
CONTROL CONTROL
IN IN
OUT OUT
EXTERNAL INTERNAL
q
You can control other Marantz products through
this unit with the remote control by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote control is
received by the remote sensor on this unit. Then the
signal is sent to the connected device through this
terminal. Therefore you only need to aim the remote
at one unit. Also, if a Marantz power amplifi er (some
models excluded) is connected to one of these
terminals, the power amplifier's, power switch is
synchronized with this unit's power switch.
Set the REMOTE CONTROL SWITCH on the units,
other than the main unit to EXT.(EXTERNAL) for this
feature.
2
RC OUT
OPTION
MODEL NO. SR MODEL NO. SR3001
MD deck
REMOTE CD player
CONTROL
IN
OUT
EXTERNAL INTERNAL EXTERNAL INTERNAL
w
Whenever external infrared sensors or similar
devices are connected to RC-5 IN of the SR3001,
be sure to always disable operation of the infrared
sensor on the main unit by using the following
procedure.
1.
Hold down the 7.1CH INPUT button and
MENU button on the front panel at the same
time for fi ve seconds.
2.
The setting "IR=ENABLE" is shown on the FL
DISPLAY.
3. Press the 1 or 2 cursor button to change this to
"IR=DISABLE".
4.
Press the ENTER button. Once this setting is
made, the infrared sensor on the main unit is
disabled.
Note:
Be sure to set to "IR=ENABLE" when external
infrared sensors or similar devices are not connected.
Otherwise, the main unit will be unable to receive
remote control commands.
5.
To restore the original setting, perform steps 1
to 4 to set to "IR=ENABLE".