Table of Contents
Advertisement
How to Install Multi Media Device
---------------------------------------------------------------------------------------------------------------------
CAUTION:
Always turn off and disconnect the power cord before opening the computer's cover to avoid an
dangerous electric shock.
Electrostatic discharge can damaged electronic components. Be sure you are properly grounded
before beging any procedure.
You can touch a metal part of the computer's chassis or power supply unit to discharge any static
charge that may have built up inside your body.
-----------------------------------------------------------------------------------------------------------------------
1. Turn your computer off and disconnect the power cord.
2. Remove the cover off the computer.
(Refer to your computer's hardware reference manual and follow the instructions to remove the
cover.)
3. Remove your existing floppy plastic cover from front computer panel.
4. Put the multi media device into the 3.5" drive bay.
5. Mount the multi media device firmly in both tracks of drive bay by four screws. ( ISO 3φ*4mm)
6. Plug the end of floppy ribbon cable back into the 34-pin floppy connector J1.
Note:
Orient the red marking on the floppy ribbon cable to J1 Pin-1. Refer to following photo.
３
Advertisement
Table of Contents
