Settings Menu - NexLink IOP-1 Instruction Manual

SETTINGS MENU
The NexLink gateway has a SETTINGS menu that allows certain setup features to be changed. It
is accessed by calling into the gateway and using DTMF tones to change the settings. CONFIG
jumper 4 on the pc board must be installed (refer to the jumper settings section). Once this
jumper is installed, the following commands will be available when calling into the gateway.
This jumper is installed when shipped from the factory. It is recommended that it be removed
once the setup is completed.
ENTER SETTINGS MODE, Press #2
When calling into the gateway the gateway will ask for a passcode. Once this pass code is
entered correctly the gateway will respond with the zone selected on the radio. At this point
the user will be in "operate" mode. The user will need to Press #2 to enter SETTINGS mode. The
gateway will respond "SETTINGS". From here you have 3 different functions:
1. NUMBER OF RINGS TO ANSWER, Press 1, then the desired number of rings.
The NexLink gateway can be programmed to answer after a set number of rings. Press DTMF 1,
then the number of rings you would like the gateway to auto‐answer the call.
2. SET THE PASSCODE, Press 2
The NexLink gateway is equipped with a 4 digit DTMF passcode feature in case an erroneous
user calls the gateway. The passcode as shipped is 1234. Press 2 in this menu and the gateway
will respond with "Enter your passcode". Enter 4 numeric digits. The gateway will repeat the
passcode to you. Press one if correct. The gateway will respond with "SETTINGS" to let you
know it has changed the passcode.
3. SET THE VOICE PROMPT VOLUME TO THE USER, Press 7 to increase, 8 to decrease.
You can set the volume of the voice prompts to the user with keys 7 and 8. 7 will increase the
volume, 8 will decrease the volume. Each time you press 7 or 8, the gateway will respond with
up and down triple tones letting you hear the level of the prompts. The gateway remembers
this level when you leave the SETTINGS menu.
Beta V1.00 07/01/2012 Page | 17