Loading Motor/Worm - JVC HR-J6009UM Service Manual

2-6: LOADING MOTOR/WORM (Refer to Fig. 2-6-A)
Remove the screw 1.
1.
2. Remove the Loading Motor.
3. Remove the Worm.
Main Chassis
• Screw Torque: 3 ± 0.5kgf•cm
NOTE
1. In case of the Worm installation, check if the value of the
Fig. 2-6-B is correct.
2. In case of the Loading Motor installation, hook the wire
on the Cassette Opener as shown Fig. 2-6-C.
Safety surface for pressing
of the insert.
2-7: TENSION ASS'Y (Refer to Fig. 2-7-B)
1. Turn the Pinch Roller Cam clockwise so that the Tension
Holder hook is set to the position of Fig. 2-7-A to move
the Tension Arm Ass'y.
2. Remove the Tension Spring.
Unlock the 2 supports 1 and remove the Tension Band.
3.
Unlock the support 2 and remove the Tension Arm Ass'y.
4.
Unlock the support 3 and remove the Tension Connect.
5.
Float the hook 4 and turn it clockwise then remove the
6.
Tension Holder.
DISASSEMBLY INSTRUCTIONS
Loading Motor
Worm
1
Fig. 2-6-A
19.2 ± 0.1mm
Fig. 2-6-B
Loading Motor
Cassette Opener
Fig. 2-6-C
Tension Arm Ass'y
Tension Connect
Tension Spring
2
4
NOTE
1. In case of the Tension Band installation, note the direc-
tion of the installation. (Refer to Fig. 2-7-C)
2. In case of the Tension Band installation, install correctly
as Fig. 2-7-D.
3. In case of the Tension Connect installation, install as the
circled section of Fig. 2-7-E.
Tension Connect
[OK]
Tension Connect
[NG]
Tension Connect
Tension Connect
Main Chassis
Fig. 2-7-A
1
1
Tension Band
3
Tension Arm Ass'y
Tension Holder
Fig. 2-7-B
Tension Band
Fig. 2-7-C
Tension Band
Tension Band
Fig. 2-7-D
Fig. 2-7-E
1-3