Advertisement
Remove the exterior and interior packing
•
Before connecting the appliance to the power source, let it stand upright
•
for approximately 2 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
Put on the space holder inside the manual bag, it helps to keep space
•
between machine and the wall to make it proper air ventilation
Clean the interior surface with lukewarm water using a soft cloth.
•
Place your appliance on a floor that is strong enough to support the
•
appliance when it is fully loaded. To level your appliance, adjust the front
legs at the bottom of the appliance.
Install away from direct sunlight and sources of heat (stove, heater,
•
radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold or hot ambient
temperatures may also cause the appliances not to perform properly.
Not designed for placement in a basement.
•
The appliance is for indoor use only.
•
It is recommended that you install the wine cooler in a location where the
ambient temperature is between 10-26 . If the ambient temperature is above or
below recommended temperatures, the performance of the unit may be
affected. For example, placing in extreme cold or hot conditions may cause
interior temperature to fluctuate. The range of 7-18°C may not be reached.
The temperature may fluctuate depending on whether or not the interior light is
on or off or whether the bottles are located on the upper, middle or lower
section.
There are three touch-buttons on the control panel
"▲" and "▼" increases or decreases the set temperature by 1°C (temp range
•
is 7-18°C).
" "button turns on or off the interior light.
•
:
This product is designed for maximum cooling of 18
•
temperature.
When the ambient temperature around 25°C or less, unit can maintain a
•
temperature range between 7-18°C.
℃
℃
below ambient
3
Advertisement
