Volvo V40 Owner's Manual page 86

03 Instruments and controls
||
Posi- Specification
tion
Main beam can be activated.
Main beam flash can be used.
On cars with active Xenon
headlamps the daytime running
light lamps are switched on
03
with reduced brightness.
A Fitted in or under the front bumper.
Volvo recommends that
when the car is being driven, as long as traffic
situations or weather conditions are unfavour-
able for the Active main beam* function.
Instrument lighting
Different display and instrument lighting is
switched on depending on key position; see
Key positions - functions at different levels
(p. 76).
The display lighting is automatically subdued
in darkness - the sensitivity is set with the
thumbwheel.
The intensity of the instrument lighting is
adjusted with the thumbwheel.
Headlamp levelling
The load in the car changes the vertical align-
ment of the headlamp beam, which could
dazzle oncoming motorists. Avoid this by
adjusting the height of the beam. Lower the
beam if the car is heavily laden.
*
84
Option/accessory, for more information, see Introduction.
1. Leave the engine running, or have the
car's electrical system in key position I.
2. Roll the thumbwheel up/down to raise/
lower beam alignment.
mode is used
Thumbwheel positions for different load cases.
Only driver
Driver and passenger in the front passen-
ger seat
Occupants in all seats
Occupants in all seats and maximum load
in the cargo area
Driver and maximum load in the cargo
area
Cars with active Xenon headlamps* have
automatic headlamp levelling and are there-
fore not equipped with the thumbwheel.
Related information
•
Position/parking lamps (p. 85)
•
Daytime running lights (p. 85)
•
Main/dipped beam (p. 86)