apivio Liberty L2 User Manual page 3

User Precautions
FCC Compliance statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
4
FCC SAR Compliance Statement
Your wireless phone is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission
(FCC) of the U.S. Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the general
population.
The guidelines are based on safety standards previously set by both U.S.
and international standards bodies:
· American National Standards Institute (ANSI) IEEE. C95.1-1992.
· National Council on Radiation Protection and Measurement
(NCRP). Report 86.1986.
· International Commission on Non-Ionizing Radiation Protection
(ICNIRP) 1996.
· Ministry of Health (Canada). Safety Code 6.
The standards include a substantial safety margin designed to assure
the safety of all persons, regardless of age and health. The exposure
standard for wireless mobile phones employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the
FCC is 1.6W/kg.
Warning
· This device is for indoor use, only in the 5150~5250Mhz frequency
range.
· This device was tested for typical body-worn operations.
· To comply with RF exposure requirements, keep at least 1.5 cm
(0.5 inches) between the user's body and the headset, including
the antenna.
· Do not use third-party belt clips, holsters, or other accessories that
contain metallic components.
· Avoid use of body-worn accessories that do not meet the above
criteria, as they may not comply with RF exposure requirements.
User manual specifications and the IP Phone software version may be
updated by the manufacturer without any notice.
5