Advertisement
Ethernet Gateway MIB tree with a short description of each field:
EGW Data
Description
*GW Section
Gateway Section
*GW Serial
Gateway Serial ID
*Version
Gateway Firmware Version
*WD Count
Wireless Device Count
*WNetSection
Wireless Network Seciont
*WD Entry
Wireless Device Entry
*Index
Index Number
*Serial
Wireless Device Serial ID
*Type
Device Type (eg temp, water, motion sensor, etc)
*Age
Number of seconds since last data recording
*Active
Indicates if the wireless device is reporting in as expected
*Alarming
Indicates if the wireless device has detected data that is urgent or
breaches a threshold
*Voltage
Battery voltage recorded at the time of data reading
*RFSignal
Signal Strength recorded on data reading delivery
*Data1
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
*Data2
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
*Data3
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
*Data4
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
*Data5
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
*Data6
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
*Data7
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
*Data8
Data recorded by wireless device (eg temperature, water de-
tected, motion detected, etc)
PAGE 16
6. Setting up the Ethernet gateway for use with iG-HUB Express
iG-HUB Express (PC Software) Setup
Visit http://www.G-HUB.com/support/downloads/ to download and install the iG-HUB
Express software.
• Launch the iG-HUB Express installer and follow the on-screen instructions.
• Launch the iG-HUB Express program.
• Activate the Express software with the code you received when purchasing.
• Add the gateway(s) and wireless sensors to the software.
• Verify that the gateway was added successfully by checking the Gateways list.
Contains FCC ID: ZTL-RFSC1
and IC: 9794A-RFSC1
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
ID: ######
Code: XXXXXX
PAGE 17
Advertisement
