Advertisement
Data Cable (DMX Cable) Requirements (For DMX Operation): The LED PAR-48 RGBW
can be controlled via DMX-512 protocol. The LED PAR-48 RGBW is an eight channel DMX unit.
The DMX address is set on the back panel LED Display of the LED PAR-48 RGBW. Your unit
and your DMX controller require a approved DMX-512 110 Ohm Data cable for data input and
data output. We recommend AZTEC / Neutrik-Cable DMX cables. If you are making your own
cables, be sure to use standard 110-120 Ohm shielded cable (This cable may be purchased at
almost all professional sound and lighting stores). Your cables should be made with a male and
female XLR connector on either end of the cable. Also remember that DMX cable must be daisy
chained and cannot be split.
Notice: Be sure to follow figures two and three when making your own cables. Do not use the
ground lug on the XLR connector. Do not connect the cable's shield conductor to the ground lug
or allow the shield conductor to come in contact with the XLR's outer casing. Grounding the
shield could cause a short circuit and erratic behavior.
programmed to act as
the "Master."
Advertisement
