Advertisement
3.
Press the "Zero-Button" to clear the
reading, then place the object you
wish to measure between the Jaws.
4.
When the Jaws of the Caliper make
gentle contact with the object, the
LCD Screen will show the correct
measurement.
5.
When finished measuring, press the
"OFF" Button to turn the Digital Cal-
liper off.
Measuring the Inside of an
1.
After turning on the Digital Calliper,
set the read-out to zero by pressing
the "Zero-Button". Make sure the
"Zero" is set while the Prongs are
closed.
2.
Place the Prongs inside the object
to be measured and gently spread
the Prongs apart until they touch the
sides of the object. See Figure 1.
3.
The LCD readout will show the mea-
surement.
4.
When finished measuring, press
the "OFF" Button to turn the Digital
Caliper off.
5.
Replace into the Case (included) and
store inside in dry area away from
children.
Measuring Depth
1.
Pull the Depth Tab out of the end of
the Digital Caliper Handle. See Fig-
ure 3 on page 5 of this manual.
2.
Place the end of the Depth Tab inside
the object whose depth you wish to
measure touching the bottom of the
object.
3.
Set the LCD Readout to zero and
slowly, push the Caliper Head down
For technical questions, please call 1-800-444-3353.
SKU 98851
Object
until the Base of the Head is even
with the top of the opening you are
measuring.
4. The depth will show on the LCD
Readout Screen.
Measuring Steps
Caliper Head
1.
Set the LCD readout to zero by
pressing the Zero-Button. Place the
Caliper Head at the base of the step
you wish to measure. See Figure 2.
2.
Slide the Caliper outside measure-
ment jaws apart to the height of the
step.
3.
The LCD readout will give you the
step height.
4.
When finished, close the Caliper Jaws
and press the "OFF" Button.
Replacing the Battery
1. Remove the Battery Compartment
Cover. See Figure 1.
Figure 2
LCD Readout
Page 4
Advertisement
