Hearthland HCFDR23 User Instructions page 12

Removing Freezer Drawer
1. Open freezer drawer.
2. Remove drawer screws on right and left sides (two
screws on each side).
Remove hex
head drawer
screw
Do not remove
other screws
Remove
hex
head drawer
screw
CAUTION
!
Drawer is heavy. Use caution when lifting.
3. Lift drawer up and out to remove.
Installing Freezer Drawer
1. With lower slides pulled out, hang drawer onto slide
brackets ensuring pins on each side are fully inserted
into slots on each side.
Assembly
Pin
Figure 25
REMOVING THE DOORS
Remove hex
head drawer
screw
Remove
hex
head drawer
screw
Figure 24
Fully extend
drawer slides
Cabinet
Slot
2. Reinstall four drawer screws (two per side), tighten
down, and close drawer (C).
Install
screws
(2) each
side
3. Check gasket seal around top, bottom, and sides of
freezer drawer.
4. If gasket is not sealed, open drawer and slightly loosen
four drawer screws (two on each side) to allow drawer
to rotate.
5. Close drawer and recheck the seal on the gasket (A).
Open the drawer grabbing by the sides in the center
(B). Be careful not to rotate the drawer.
Push
against
freezer
drawer
A
6. Tighten four drawer screws.
7. Recheck gasket seal.
8. Install the toe grille by fitting into place.
12
Figure 26
Grab drawer
at center
from both
sides, then
pull drawer out
B
Figure 27