Timer Mode - Extech Instruments 365535 User Manual

A ready period of 2 seconds will be counted. At the end of the ready period, all the lap records of the
corresponding segment will be erased. And a long beep sound will be heard. Then the display will show the
next segment. If you don't want to delete the records, you can press any key to exit from delete ready state
b e f o r e t h e e n d o f t h e r e a d y p e r i o d a n d r e s u m e t h e d i s p l a y o f t h e s e g m e n t f r o n t p a g e .
How to delete all memory segments:-
Instead of deleting one segment, you can also delete all memory segments. When you enter the Data mode,
you see the screen FREE XXX LAP . Press and hold the [RESET] for 3 seconds.You will hear Beep, beep,
beep for 3 seconds, then a long Beep . At this point all data in the memory will be deleted and DELETE
ALL will show on the display.
If you don't want to delete the records, you can press any key to exit DELETE ALL state before the end of
the ready period and resume the display of the segment front page.

Timer Mode

Press [MODE] until you enter the Timer mode. 3 count-down operation modes are available on this stopwatch:
- Count down repeat ( CR)
- Count down stop (CS)
- Count down, then count up (CU)
The timer is set at the factory to the count-down repeat (CR) mode. At entering timer mode, the mode message
TIMER will be shown for a second before the timer counting is to be displayed.
{000}
CR
The upper line shows the programmable timer value (initially set at 0:00:00:0) while the middle line displays the
current timer counting. Time of Day clock display is at the lower line of the display. CR indicates the current timer
operating mode while the timer cycle counter is located at the upper left of the display.
13
dELETE
ALL
0:00'00"0
0:00'00"0
A 12:58'20
365535-en-GB_V1.2 1/15