Finding A Station; Playing The Radio - Cadillac Escalade Manual

Navigation Audio System
Notice: Before adding any sound equipment to
your vehicle, like a tape player, CB radio, mobile
telephone, or two-way radio, make sure that it can
be added by checking with your dealer. Also,
check federal rules covering mobile radio and
telephone units. If sound equipment can be added,
it is very important to do it properly. Added
sound equipment may interfere with the operation
of your vehicle's engine, radio, or other systems,
and even damage them. Your vehicle's systems may
interfere with the operation of sound equipment
that has been added improperly.
Your vehicle has a feature called Retained Accessory
Power (RAP). With RAP, the audio system can be
played even after the ignition is turned off. See
"Retained Accessory Power (RAP)" in Section 2 of your
vehicle's owner manual for more information.
The audio system is operated using navigation system
menus. The audio menus are explained in this section.

Playing the Radio

O (Power/Volume): Press this knob to turn the audio
and navigation systems on and off. Turn the knob to
increase or decrease the volume.
3-2

Finding a Station

BAND: Press this hard key to access the BAND screen
and to switch between AM, FM1, FM2, XM1, and
XM2, if equipped.
Tuning Knob: Use the tuning knob on the lower left
corner of the navigation system to choose a radio station.
w x
SEEK : Press the SEEK up or the down arrow to
go to the next or previous station and stay there.
To scan stations, press and hold the SEEK up or down
arrow for two seconds until you hear a beep. The
radio will go to a station, play for a few seconds, then
go on to the next station. Press either SEEK arrow again
to stop scanning.
To scan preset stations, press and hold the SEEK up or
down arrow for more than four seconds. You will hear
two beeps and PSCAN will be displayed, along with the
highlighted preset. The radio will go to one of the
preset stations, play for a few seconds, then go on to
the next preset station. Press either SEEK arrow
again to stop scanning presets.
The radio will only seek and scan stations with a strong
signal that are in the selected band