Table of Contents
Advertisement
ENG
REPLACING COMPONENTS WITH SPARES
ATTENTION: This section exclusively concerns technical assistance personnel.
IMPORTANT: Before making any repairs, switch off at the mains switch and disconnect the appliance from the
power supply.
Do not touch sealed components.
Radiant heating element
Remove top cover panel and insulation. Remove element support bars. Disconnect the faulty heating
element and remove. Replace the element and reassemble in the reverse order.
Control switch
Remove control knobs and control panel. Unscrew the switch fixing screws. Swap cables to new switch
and replace. Reassemble in reverse order.
Micro switch
Remove control panel. Unscrew the switch fixing screws. Swap cables to new switch and replace.
Reassemble in reverse order.
Mechanical timer
Remove the control knob and control panel. Unscrew the timer fixing screws and replace. Reassemble in
reverse order.
Neon
Remove the control panel. Disconnect wires remove and replace neon. Reassemble in reverse order.
Glass
Remove top cover panel and insulation. Remove element support bars. Remove element to access glass
and replace. Reassemble in the reverse order.
INSTRUCTIONS FOR USE AND MAINTENANCE
ATTENTION: This appliance is intended for professional use and therefore must be used by qualified or trained
personnel. It is essential to monitor the appliance during use. During operation, parts may become hot – avoid
accidental contact. Be aware of the
Installation and conversion to different voltages must be carried out by qualified and authorised installers. In the
event of problems or malfunction, switch off the appliance at the mains. In the event of a damaged supply cord, it
must be replaced by the manufacturer, its service agent or similarly qualified person.
For repairs, refer only to the authorised assistance centre and use only genuine replacement parts
Before using the appliance, read this manual and keep it for future reference.
Clean all surfaces before first use.
Never leave the cooking surface on when not in use.
The manufacturer assumes no liability resulting from any failure to observe the instructions in this manual.
Operation
Note:
The HiLight elements have built-in temperature monitoring. Due to this temperature monitoring the maximum
temperature is limited to 250deg. During continuous use the elements will automatically turn on/off to prevent
damage to the element if this temperature is reached.
IS560 ECN 3731
surfaces in the region of the reflectors are hot
Page 5 of 10
Advertisement
Table of Contents
