Advertisement
Quick Links
Advertisement
Related Manuals for Manley Langevin 20 BIT DIGITAL TO ANALOG CONVERTER
Summary of Contents for Manley Langevin 20 BIT DIGITAL TO ANALOG CONVERTER
- Page 1 MANLEY LABORATORIES, INC. OWNER'S MANUAL 20 BIT DIGITAL TO ANALOG CONVERTER...
-
Page 2: Table Of Contents
SECTION INTRODUCTION MAINS CONNECTIONS FRONT PANEL REAR PANEL OPERATIONAL NOTES WARRANTY WARRANTY REGISTRATION NOTES CONTENTS PAGE... -
Page 3: Introduction
INTRODUCTION THANK YOU!... for choosing the Langevin Digital To Analog Converter. The Langevin Digital To Analog Converter utilizes only the most modern componentry including the decidedly best 20 BIT Ultra Analog (TM) system, precision 1% metal film resistors, and highly regulated power rails. Please take a few moments to read through this manual carefully as it contains information essential to proper operation of this unit. -
Page 4: Mains Connections
Your unit has been factory set to the correct mains voltage for your country. The voltage setting is marked on the serial badge, located on the rear panel. Check that this complies with your local supply. Export units for certain markets have a moulded mains plug fitted to comply with local requirements. If your unit does not have a plug fitted the coloured wires should be connected to the appropriate plug terminals in accordance with the following code. -
Page 5: Front Panel
SET LEVEL PROGRAM 0º 180º MUTE GAIN SET PHASE SELECT POWER LED POWER SWITCH FRONT PANEL Factory set for a total gain of 8 dB, this control can be adjusted from as little as 3dB of gain to as much as 10dB To increase the volume of the Left channel turn control counter-clock-wise from center position. -
Page 6: Rear Panel
FUSE CIRCUIT GROUND CHASSIS IEC MAINS SOCKET DAISY CHAIN (If provided) FUSE HOLDER CIRCUIT, CHASSIS GROUND TERMINALS MAIN OUTPUT (XLR) MAIN OUTPUT (RCA) S/PDIF INPUT S/PDIF or AES SELECT SWITCH AES INPUT REAR PANEL Accepts standard 50/60 Hz AC mains voltage. The incoming AC mains voltage is paralleled via this IEC plug and can power another unit simultaneously. -
Page 7: Operational Notes
OPERATIONAL NOTES SWITCHING ON The power switch is located on the right hand corner of the front panel. Flip the switch up to turn on the unit and down to turn off the unit. When powering up or down this unit, it is recommended to have the LANGEVIN DAC muted as to avoid amplifying powering up/down noises which occur as the digital receiver "loses clock"... - Page 8 SPECIFICATIONS...
-
Page 9: Warranty
WARRANTY All Manley Laboratories equipment is covered by a limited warranty against defects in materials and workmanship for a period of 90 days from date of purchase to the original purchaser only. A further optional limited 5 year warranty is available to the original purchaser upon proper registration of ownership within 30 days of date of first purchase. -
Page 10: Warranty Registration
WARRANTY REGISTRATION We ask that you please fill out this registration form and send the bottom half to: Registration entitles you to product support, full warrenty benefits, and notice of product enhancements and upgrades. You MUST complete and return the following to validate your warranty and registration. -
Page 11: Notes
NOTES...