How To Attach The Stand; How To Remove The Stand / Wall Mounting; To Remove Stand/Wall Mounting - Hitachi LE55A6R9 Owner's Manual

How to attach the stand

NOTE:
• Assure the AC cord is not connected to an AC outlet.
• Before beginning this process, make sure that you have a clean, safe, and cushioned
space to work at to avoid any damage to the unit.
• Do not touch or press the LCD screen, the glass might break under pressure.
1
Carefully place the TV screen face-down on a clean, cushioned surface.
2
Insert and secure the stands (R and L) with 2 screws (supplied) (M8x16mm) each side
as shown in Figure 1.
R L
Stands
• Be sure to follow the above instructions. Insufficient tightening or incorrect installation of
the stand will not support your TV correctly, and could result in damage or injury from tip-
over.

How to remove the stand / Wall mounting

When you transport this product, remove the stand and pack it flat against the back of the
unit in the carton. To remove the stand, perform the above steps in reverse order.
When you mount the TV on the wall, remove both stands (R and L). To disconnect the stand
remove the screws from the bottom of TV.
Wall mounting:
• Before wall mounting, please carefully check the location of the TV's mounting-holes.
• If the unit is to be mounted on the wall, contact the retailer where you purchased the
TV for advice, and have the equipment professionally installed. Incomplete or improper
installation may cause injury to you, and/or damage to the TV. The screws ISO
type should be used. The insertion length must
20-21mm for Bottom Wall Mount Hole. If the insertion length is less than or more than
specified above, the weight can not be maintained or a
Mount Bracket and the Television.
(Insertion Length) = (Screw Length) - (Washers Thickness) - (Mounting Bracket Thickness)
8
R
Stands
Screws
Screws
be 21-30mm for Top Wall Mount Hole and
space is created between the Wall
Figure 1
L
Top Wall Mount Hole
Bottom Wall Mount Hole
M6 thread