Installing The Batteries Into The Digital Pad; Installing The Battery Into The Digital Inking Pen - Acecad DigiMemo L2 User Manual

Installing the Batteries into the Digital Pad

Open the battery compartment cover of the
digital pad. Insert four batteries (1.5 volt, size
AAA) into the battery compartment in
accordance with the indication in the battery
compartment.
compartment cover.
Note! Incorrect battery installation may
damage the digital pad.
Note! Do not mix new and used batteries.
Note! With continuous use of the digital pad, four AAA alkaline batteries will last
approximately 80 hours.

Installing the Battery into the Digital Inking Pen

Unscrew the barrel cover counterclockwise from the barrel of
the pen. Take out the button cell battery (SR626SW, 377 or
IEC-SR66) that is included in the package of the DigiMemo.
Insert the battery into the battery compartment with the
negative (-) cap facing the battery compartment. Screw the
barrel cover clockwise onto the barrel until tight.
Note! Incorrect
malfunction of the digital inking pen.
Pen Clip
Pen Cap
Note! The battery of the digital inking pen will last
approximately 14 months.
Note! The front or rear section of the pen can hold the pen
cap.
Note! You can attach some cord or accessory to
the pen through the two holes on the pen
end.
Note! You can clip the pen to the pad by using the
pen clip to clip to the right or left pen holder
on the notepad clip.
Note! You can attach some cord or accessory
such as the pen to the pad through the two
Close the
battery installation
Front Section
Ink Cartridge
battery
will result in
Barrel
Barrel Cover
(+) Can
(-) Cap
the
Battery
Compartment
Rear Section
Pen End
Two Holes
3