IMPORTANT – Please Read and Follow • Before beginning, please read these • DO NOT remove permanently affixed instructions completely and carefully. labels, warnings, or plates from the product. This may void the warranty. • Please observe all local and national Your safety and the safety of others is codes and ordinances.
Page 4
IMPORTANT – Please Read and Follow WARNING CAUTION BURN HAZARD Be sure the electric power is off from the breaker box to the The use of cabinets for junction box until the cooktop storage above the appliance is installed and ready to may result in potential burn operate.
Cutout Dimensions 30” W. 36” W. 45” W. 28-7/8” (73.3 cm) min. to 34-7/8” (88.5 cm) min. to 43-1/8” (109.5 cm) min. to 29-7/8” (75.9 cm) max. 35-7/8” (91.1 cm) max. 44-1/8” (112.1 cm) max. 20” (50.8 cm) min. to 20-1/4” (51.4 cm) max. 2-1/2”...
Clearance Dimensions (Proximity to Cabinets) Proximity to Side Cabinet Installation Minimum Clearances from Adjacent Combustible Construction • The cooktop may be installed directly to existing base cabinets. • Above countertop 36” (91.4 cm) minimum • The cooktop CANNOT be installed •...
Clearance Dimensions (Wood/Composite Overlay) The bottom of a standard hood should be 30” (76.2 cm) min. to 36” (91.4 cm) max. / C o above the countertop. This would typically o s i e r l result in the bottom of the hood being 66”...
Electrical Requirements Electrical Requirements Electrical Connection Check your local codes regarding this unit. WARNING This cooktop is supplied with a 3-wire, A.C. 208Y/120 volt or 120/240 volt, 60 HZ electrical system. A white (neutral) is not The electrical power to the needed for this unit.
General Information READ AND FOLLOW ALL WARNING WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE. ELECTRICAL GROUNDING • All openings in the wall behind the INSTRUCTIONS appliance in the floor under the appliance shall be sealed This cooktop must be electrically •...
Installation Green Neutral Black Lower cooktop into cutout. Connect the red and black leads from the unit conduit to the corresponding leads in the junction box. Cooktop Cooktop Countertop Countertop Filler Filler Block Block Screw Eye Bolt Bracket Bracket After placing cooktop in the cutout, screw brackets Screw sheet metal screws into brackets to burner box with sheet metal screw.
Final Preparation • Some stainless steel parts may have a If it is necessary to scrape stainless steel plastic protective wrap which must be to remove encrusted materials, soak with peeled off. hot, wet cloths to loosen the material, • All stainless steel body parts should be then use a wood or nylon scraper.
Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range at 1-888-845-4641 for the nearest service parts distributor in your area or write to: VIKING RANGE, LLC...
Page 16
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641 or our website at vikingrange.com in the US or brigade.ca in Canada F21213B EN (090115)